A–Simple Network Management Protocol (SNMP)Management Information Base (MIB)A-2 ISR645610-00 BSNMP Trap ConfigurationSNMP trap configuration supports setting up to eight trap destinations. Choosefrom Traps 1 through 8 to configure each trap. Table A-2 describes theparameters for configuring an SNMP trap.Management Information Base (MIB)The following sections describe the QLogic management information base (MIB).The MIB consists of four object groups: “System Information” on page A-3 “Network Port Table” on page A-4 “Fibre Channel Port Table” on page A-6 “Sensor Table” on page A-8System contact Specifies the name of the person to be contacted to respond totrap events. The name can be up to 64 characters excludingthe number sign (#), semicolon (;), and comma (,). The defaultis undefined.Authentication traps Enables or disables authentication trap generation in responseto authentication failures. The default is disabled.Table A-2. SNMP Trap Configuration ParametersParameter DescriptionTrap n enabled Enables or disables trap n. If disabled, the trap is not configured.Trap address aa Traps (other than 0.0.0.0) and trap port combinations must be unique. For example, if trap 1 andtrap 2 have the same address they must have different port values. Similarly, if trap 1 and trap 2have the same port value, they must have different addresses.Specifies the IP to which the SNMP traps are sent. A maximum ofeight trap addresses is supported. The default for traps is 0.0.0.0.Trap port a The port number on which the trap is sent. The default is 162.Trap version Specifies the SNMP version (1 or 2) with which to format traps.Table A-1. SNMP Properties (Continued)Parameter Description
