3–InstallationInstalling the iSR6200 Router3-6 ISR651101-00 CConnecting the Router to AC PowerFigure 3-1 shows the front and back plates of an iSR6200 router chassis thatcontains two router blades with add-in ports installed for its model. Each powercooling module (PCM) provides a power connector, as well as a Status LED.Figure 3-1 iSR6200 Router Chassis — Front and Back PlatesUse Figure 3-1 to locate the power connector and PCM status LED for the bladeyou’re configuring.WARNING!!This product is supplied with a 3-wire power cable and plug for the user’ssafety. Use this power cable in conjunction with a properly grounded outletto avoid electrical shock. An electrical outlet that is not correctly wired couldplace hazardous voltage on metal parts of the router chassis. The customermust make sure the outlet is correctly wired and grounded to preventelectrical shock.You may require a different power cable in some countries because the plugon the cable supplied with the equipment will not fit your electrical outlet. Inthis case, you must supply your own power cable. The cable must meet thefollowing requirements: For 125 Volt electrical service: the cable must be rated at 10 Amps andbe approved by UL and CSA. For 250 Volt electrical service: the cable must be rated at 10 Amps, meetrequirements of H05VV-F, and be approved by VDE, SEMKO, andDEMKO.MGMT IOIOIFC1 FC2MGMT IOIOIFC1 FC210GbE1 iSR6250Intelligent Storage Router10GbE2 10GbE1 iSR6250Intelligent Storage Router10GbE2Expansion SlotFront Plate iSR6200 Blade 1 Front Plate iSR6200 Blade 2Back Plate PCM for Blade 2 Back Plate PCM for Blade 1Expansion SlotPCM Status LED PCM Status LEDPower Connector Power Connector
