3–InstallationInstalling the iSR6200 RouterISR651101-00 C 3-7To power on the router:1. Attach the AC power cord to the power connector, located on the back sideof the PCM connected directly behind the router blade.2. Connect the opposite end of the power cord to a grounded AC wall outlet orpower strip.3. Check the PCM power LED to make sure the fan is operational (green = OK,yellow = no AC power).Figure 3-2 shows the location of the ports and LEDs on one of the bladescontained within the iSR6200 unit that are referenced in the followinginstructions.Figure 3-2 iSR6200 Blade Ports and LEDs4. Verify that the router’s input power LED is illuminated.The iSR6200 router runs its self test and begins normal operation—this maytake a minute.5. Verify that the heartbeat LED is blinking (once per second) and that thesystem fault LED is not illuminated.If an error has occurred, the system fault LED blinks a pattern that indicates thefault reason. For more information about error blink patterns, see page 6-2.Connecting the Management Workstation to the RouterYou can manage the router using the SANsurfer Router Manager or the commandline interface (CLI). SANsurfer Router Manager requires an Ethernet connectionto the router. CLI can use an Ethernet connection or a serial connection. Choosethe router management method, and then connect the management workstationto the router in one of the following ways: Indirect Ethernet connection from the management workstation to the routerRJ-45 connector through an Ethernet switch or hub. This requires a 10/100Base-T straight cable.MGMT IOIOI FC1 FC2 GE1 GE1GE4 GE3 iSR6240Intelligent Storage RouteriSR6200 System10GbE1 iSR6250Intelligent Storage Router10GbE2Management Port System Fault LEDRS232 Port Heartbeat LED Power LEDFC Ports iSCSI PortsExpansion Ports Based on Model
