Quadra-Fire 31M-ACC-GT Owner's Manual

Quadra-Fire 31M-ACC-GT Owner's Manual Manual pdf 21 page image

March 2, 2007 7033-277C Page 213100 Wood Stove Series (ACC)R7 Appliance Set UpFigure 21.3Do NOT operate before fully assembling components.Burning your stove without a pedestal or leg kitattached:• Will void your warranty.• May result in property damage or personal injury.WARNINGNOTE: The Ash Removal System, must beinstalled first before installing the pedestal.A. Pedestal Assembly and Ash RemovalSystem (ARS) Installation for Step TopUni-bodyIncluded in Kit: Door assembly, door handle & magnet,ash grate, ash grate channel, ash drawer, fastener package.A cover plate that is required for a floor outside air instal-lation on a pedestal model is also included, If not needed,discard.Tools Required: Phillips head screw driver, 7/16 socketwrench, 3/32 and 5/36 Allen wrench.Begin installing the ARS System.1. Remove 2 bricks as shown in Figure 21.12. Lay body of stove on its back on a protective pad or pallet.3. Remove the 2 nuts and 2 bolts holding the grate in placeand set the grate aside. Discard the 2 nuts. I nstall thegasket over the 4 protruding screws. Figure 21.2.4. Install ash door assembly by sliding the rod at an angleinto the slot on the left side and sliding over the 4 screwsprotruding from the bottom of the stove. Secure with nutsprovided. Figure 21.2.5. Install magnet using a Phillips head screw driver. Thismagnet will hold the door handle in an open positionwhich in turn holds the ash door open so ashes can bebrushed into the ash drawer. Figure 21.2.6. Install door handle by placing over rod and sliding to theright. While in an open position, line up the set screw withthe flat side of the rod and tighten the set screw usinga 3/32 Allen wrench. The set screw needs to be snug.Figure 21.3.Door handle must bein open position totighten set screwSet Screw(align with flatside of rod)Ash Door Rod shownin installed position2 2Remove forinstallation andthen re-installGasketSlide rod at anangle into slotAsh DoorAssemblyMagnetLay stove flat onprotective padding orpalletDoor HandleFigure 21.1Figure 21.2