Quadra-Fire 51I-ACC Owner's Manual

Also see for 5100-I ACC: Installation manual

Contents

Quadra-Fire 51I-ACC Owner's Manual Manual pdf 19 page image

December 20, 2011 7047-148CPage 1951I A C C W ood I nsertR• Frequency: As desired• By: Homeowner• Clean glass with a non-abrasive glass cleaner. Abrasivecleaners may scratch and cause glass to crack.• If the deposits on the glass are not very heavy, normalglass cleaners work well. Heavier deposits may beremoved by using a damp cloth dipped in wood ashes orby using a commercially available oven cleaner.• After using an oven cleaner, it is advisable to remove anyresidue with a glass cleaner or soap and water. Ovencleaner left on during the next firing can permanentlystain the glass and damage the finish on plated metalsurfaces.• A portion of the combustion air entering the firebox is de-flected down over the inside of the door glass.• This air flow “washes” the glass, helping to keep smokefrom adhering to its surface.• When operated at a low burn rate, less air will be flowingover the glass and the smoky, relatively cool condition ofa low fire will cause the glass to become coated.• Operating the appliance with the Burn Rate Air Controland Start-Up Air Control all the way open for 15-20 min-utes should remove the built up coating.E. Glass CleaningCAUTION! Handle glass assembly with care. Glass isbreakable.• Avoid striking, scratching or slamming glass• Avoid abrasive cleaners• Do not clean glass while it is hotReplace the firebrick if they become crumbly and/or ifthere is a 1/4 inch (6.35mm) gap between the bricks.The firebox is lined with firebrick, which has exceptionalinsulating properties. Do not use a grate; simply builda fire on the firebox floor. Do not operate appliancewithout firebrick.1. After the coals have completely cooled, remove allold brick and ash from unit and vacuum firebox.2. Remove new brick set from box and lay out to thediagram shown in the instructions that come withthe brick set or refer to the diagram on the serviceparts list at the end of this manual.3. Lay bottom bricks in unit.4. Install rear bricks on the top of the bottom bricks.Slide top of bricks under clip on back of firebox walland push bottom of bricks back.5. Install side bricks. Slide top of brick under clipson side of firebox and push the bottom of the brickuntil it is flush with the side of the unit.F. Inspect Firebrick• Frequency: After each ash removal• By: Homeowner