Page 67047-148C December 20, 2011R51I ACC Wood Insert1 Listing and Code ApprovalsThe Quadra-Fire 5100 Wood Insert (ACC) meets the U.S.Environmental Protection Agency’s 1990 particulate emis-sion standards.A. Appliance CertificationC. Glass SpecificationsD. BTU & Efficiency SpecificationsThis stove is equipped with 5mm ceramic glass. Replaceglass only with 5mm ceramic glass. Please contact yourdealer for replacement glass.B. Mobile Home ApprovedEPA Certified: 4.16 grams per hourEfficiency: up to 80.5%BTU Output: 10,500 to 27,900Heating Capacity: 2,250 to 3,175 sq ft depend-ing on climate zoneVent Size: 6 inchesFirebox Size: 3 cubic feetMax Wood Length: 20 inchesFuel: Cord WoodShipping Weight: 480 lbsModel: 5100-I (ACC) InsertLaboratory: IntertekReport No: 100323198PRT-001aType: Solid Fuel Type, Listed Room HeaterStandard: UL1482 and ULC S628-93 and(UM) 84-HUD, Mobile HomeApproved.NOTE: Hearth & Home Technologies, manufacturer ofthis appliance, reserves the right to alter its products,their specifications and/or price without notice.NOTE: This installation must conform with local codes. In theabsence of local codes you must comply with the UL1482, (UM)84-HUD and NPFA211 in the U.S.A. and the ULC S628-93 andCAN/CSA-B365 Installation Codes in Canada.• This appliance is approved for mobile home installa-tions when not installed in a sleeping room and whenan outside combustion air inlet is provided.• The structural integrity of the mobile home floor, ceil-ing, and walls must be maintained.• The appliance must be properly grounded to the frameof the mobile home with #8 copper ground wire, andchimney must be listed to UL103 HT or a listed UL-1777 full length six inch (152mm) diameter liner mustbe used.• Outside Air Kit, part OAK-ACC must be installed in amobile home installation.Improper installation, adjustment, alteration, service ormaintenance can cause injury or property damage.For assistance or additional information, consult a qualifiedinstaller, service agency or your dealer.Quadra-Fire is a registered trademark of Hearth & HomeTechnologies.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approvedby Hearth & Home Technologies.• Operating appliance without fully assembling all components.• Operating appliance without legs attached (if supplied withunit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions: