Quadra-Fire CASTILEI-MBK Owner's Manual

Also see for CASTILEI-CSB: Owner's manual Owner's manual installation and operation Installation manual Owner's manual Manual

Quadra-Fire CASTILEI-MBK Owner's Manual Manual pdf 21 page image

RJanuary 19, 2011 7022-122 Page 21Castile Pellet InsertBase Plate Only InstallationParts Needed: (1) cast ring (2) base zero clearance panelextensions. Discard balance of parts.Tools Needed: Phillips head screwdriver1. Attach base zero clearance panel extensions to castring.2. Place assembly under appliance.Panel ExtensionPanel LegCast Trim FooterFigure 21.1G. Surround & Trim Set, EconoBack of Top PanelBack of Side PanelScrewsIncluded in Surround Kit: 2 side pieces, left and right,top piece and fastener package.Included in Basic Trim Kit: 2 side pieces, left and right, toppiece and “L” brackets.Tools Needed: 4-6 inch long Philips head screwdriver,pliers and fl at head screwdriver1. Lay surround face down on a fl at protected surfaceto prevent scratching.2. Using the Philips head screwdriver attach the sidesurrounds to the top surround using 2 sheet metalscrews provided with the kit on each side.3. Assemble the trim with the two corner bracketsprovided.4. Slide the assembled trim over the assembledsurround set.5. Remove the cast sides before attaching the surroundand trim. Lift up the top to expose the thumb screwsthat secure the cast sides. Remove the thumb screwand top bracket and then remove the cast side.NOTE: The right cast side bracket has the hoppercut out switch attached. Remove the retainer fromthe right side and allow to hang down into the insertor disconnect the switch when removing side.6. Install the power cord in the surround.7. If power enters the appliance on the right side:Using the pliers, attach cord restraint 12 inches fromthe female end of the cord and then press into theright side panel. Figure 21.2. Figure 21.4F. Hearth Support (Cont’d) 8. If power enters appliance on the left side: The cord willhave to be routed through the back of the insert. Whenrouting the power cord, keep cord lying fl at as possible,keeping the cord away from all exhaust surfaces andmoving parts. After routing, install cord restraint andpress into the left side panel.9. Slide surround over the top of the insert into place.Surround attaches to bottom and top of insert sides withthe supplies 1/4 inch screws.10. Plug cord into inlet on junction box routing the wire asshown in Figure 21.3.11. Install plug into unused hole.12 in (305mm)Figure 21.2Plug Cord into Junction BoxFigure 21.3