Quadra-Fire Expression 36 Owner's Manual

Also see for Expression 36: Owner's manual

Contents

Quadra-Fire Expression 36 Owner's Manual Manual pdf 4 page image

Quadra-Fire • Expression 36 (QV36A-FB) • 2062-900 Rev. Q • 2/104Note: This installation must conform with local codes. In theabsence of local codes you must comply with the NationalFuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. andthe CAN/CGA B149 Installation Codes in Canada.11 Listing and Code ApprovalsB. BTU Specifi cationsMODELS: QV36A-FBLABORATORY: Underwriters Laboratories, Inc. (UL)TYPE: Direct Vent Gas Appliance HeaterSTANDARD: ANSI Z21.88-2002 • CSA2.33-M02 • UL307BDo NOT use this appliance if any part has been under water.Immediately call a qualified service technician to inspect theappliance and to replace any part of the control system andany gas control which has been under water.This product is listed to ANSI standards for “Vented GasAppliance Heaters” and applicable sections of “Gas Burn-ing Heating Appliances for Manufactured Homes andRecreational Vehicles”, and “Gas Fired Appliances forUse at High Altitudes”.Expression 36(QV36A-FB)MaximumInputBTUHMinimumInputBTUHOrifi ceSize(DMS)(NG)US(0-2000 FT) 37,000 24,000 32CANADA(2000-4500 FT) 33,300 21,600 33(LP)US(0-2000 FT) 36,000 26,000 50(2000-4500 FT) 32,400 23,400 51A. Appliance CertificationD. Non-Combustible Materials Specifi cationMaterial which will not ignite and burn. Such materials arethose consisting entirely of steel, iron, brick, tile, concrete,slate, glass or plasters, or any combination thereof.Materials that are reported as passing ASTM E 136,Standard Test Method for Behavior of Materials in aVertical Tube Furnace at 750ºC, shall be considerednon-combustible materials.E. Combustible Materials Specifi cationMaterials made of or surfaced with wood, compressedpaper, plant fibers, plastics, or other material that can ig-nite and burn, whether flame proofed or not, or whetherplastered or unplastered shall be considered combustiblematerials.F. Electrical CodesNOTICE: This appliance must be electrically wired andgrounded in accordance with local codes or, in the absenceof local codes, with National Electric Code ANSI/NFPA70-latest edition or the Canadian Electric Code CSAC22.1.• A 110-120 VAC circuit for this product must be protectedwith ground-fault circuit-interrupter protection, in compliancewith the applicable electrical codes, when it is installed inlocations such as in bathrooms or near sinks.WARNINGNOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.This appliance is tested and approved as either supplemen-tal room heat or as a decorative appliance. It should not befactored as primary heat in residential heating calculations.C. High Altitude InstallationsU.L. Listed gas appliances are tested and approved with-out requiring changes for elevations from 0 to 2000 feet inthe U.S.A. and Canada.When installing this appliance at an elevation above 2000feet, it may be necessary to decrease the input ratingby changing the existing burner orifice to a smaller size.Input rate should be reduced by 4% for each 1000 feetabove a 2000 foot elevation in the U.S.A., or 10% for el-evations between 2000 and 4500 feet in Canada. If theheating value of the gas has been reduced, these rulesdo not apply. To identify the proper orifice size, check withthe local gas utility.If installing this appliance at an elevation above 4500 feet(in Canada), check with local authorities.