Quadra-Fire • QV36DC-A • 2161-900 Rev. B • 10/08 31Figure 38.Figure 39.Figure 40.Figure 39.Figure 42.Position the right wall all the way to back wall. Secure in po-sition same as was done for the left wall (see Figure 42).Installing the TrimCombustible materials may be brought up to the specifiedclearances on the side and top front edges of the fi replace,but MUST NEVER overlap onto the front face. The jointsbetween the finished wall and the fireplace top and sidescan only be sealed with a 300° F. (149° C) minimumsealant.Step 10. Installing Trim, Refractory, Logs,and Ember MaterialRefractory Kit Placement (BRICK-292)CAUTION: REFRACTORY IS FRAGILE! CAREFULLYREMOVE THE REFRACTORY FROM THE PACKAG-ING.Remove the logs and log grate from the fireplace. Placethe back wall refractory centered against the back of thefireplace on the back refractory ledge (see Figure 38).When positioning the left wall use care in not knockingthe back wall down. Position the left wall all the way backagainst the back wall. Using the retaining clip and screwincluded, secure the side wall refractory as shown (seeFigures 39 and 40).WARNING: WHEN FINISHING THE FIREPLACE,NEVER OBSTRUCT OR MODIFY THE AIR IN-LET/OUTLET GRILLES IN ANY MANNER.!Install optional marble and brass trim surround kits asdesired. Marble, brass, brick, tile, or other non-combustiblematerials can be used to cover up the gap between thesheet rock and the fireplace.Do not obstruct or modify the air inlet/outlet grilles. Whenoverlapping on both sides, leave enough space so that thebottom grille can be lowered and the trim door removed.