Quadra-Fire VOYA-GRAND-MBK Owner's Manual

Also see for VOYA-GRAND-MBK: Installation manual Installation manual Owner's manual Owner's manual Owner's manual

Contents

Quadra-Fire VOYA-GRAND-MBK Owner's Manual Manual pdf 38 page image

Page 387075-166C May 23, 2013RVOYAGEUR GRAND Wood InsertOvalizing round stainless steel liners to accommodate theliner passing through the damper region of a fireplace is anallowable and acceptable practice.Ensure that the ovalization is minimized to the extentrequired to fit through the damper.J. Ovalizing Round Stainless Steel LinersFire Risk.Do NOT pack insulation or other combustiblesbetween spacers.• ALWAYS maintain specified clearances aroundventing and spacers.• Install spacers as specified.Failure to keep insulation or other material away fromvent pipe may cause fire.WARNINGK. Chimney Height / Rise and RunTo be sure that your Quadra-Fire insert burns properly, thechimney draft (static pressure) should be approximately -0.10inches water column (W.C.) during a high burn and -0.04inches W.C. during a low burn, measured 6 inches (152mm)above the top of the insert after one hour of operation at eachburn setting.NOTE: These are guidelines only, and may vary somewhatfor individual installations.• This product was designed for and tested on a 6 inch(152mm) chimney, 14 to 16 feet (4.27-4.87m) high, (in-cludes appliance height) measured from the base of theappliance.• The further your stack height or diameter varies from thisconfiguration, the possibility of performance problems ex-ists.• Chimney height may need to be increased by 2 - 3% pereach 1000 feet (304.8m) above sea level.• It is not recommended to use offsets or elbows at altitudesabove 4000 feet (1219.2m) above sea level or when thereare other factors that affect flue draft.Fire Risk.This appliance relies upon natural draft to operateproperly.• Chimney heights exceeding 25 feet (7.62m) frombase of appliance may create an over-draft situation.• Overdraft condition may create over-firing.Over-firing may ignite creosote and/or damage appli-ance and chimney.WARNINGFire Risk.Failure to install a full reline may cause:• Creosote accumulation creating increased risk ofchimney fire.• Lose protection to combustible surfaces from theliner in case of fire.• Poor performance and start-ups.• Less access to chimney for required maintenance.WARNING