Quadro6L/4L Manual I: Installation Guide Step 2: Configuring the QuadroStep 2.3: Internet Configuration WizardOpen the Internet Configuration Wizard by selecting the corresponding menu item on theSystem menu. The Internet Configuration Wizard is a tool for the administrator to config-ure the WAN settings and to adjust Quadro's connectivity in the global network. It must berun if Quadro is desired to be connected to the Internet.The page Getting Started will be displayed:Fig. l- 25: Internet Configuration WizardThis first page of the Internet Configuration Wizard is for informational purposes only andlists the items to be configured, Click on the Next button for the Uplink Configurationpage.Before configuring the WAN port to the Internet, you need to get the following informationfrom your internet service provider:• Bandwidth - how much is available upstream and downstream?• WAN IP Configuration - is DHCP supported? If yes, no more information isneeded. If DHCP is not supported, the following data is needed: the WAN IP ad-dress, the subnet mask, the IP address of the standard gateway and the IP ad-dress of the Domain Name Server (DNS).• MAC address - needed when the ISP requires a specific MAC address for theWAN.Additionally, for Point-to-Point Protocol over Ethernet (PPPoE) WAN interface, you need toget the following information from your internet service provider:• PPP Configuration - does your ISP use a dynamic or fixed WAN IP address? Ifthe WAN IP address is dynamic, no more information is needed. If the WAN IPaddress is fixed, you will have to enter it.• Authentication - does your ISP require authentication? If authentication is re-quired, information about the corresponding method (PAP, CHAP or MSCHAP) isneeded including the username and password of the PPPoE account.This information will be needed to be inserted in the Internet Configuration Wizard.Quadro6L/4L; (SW Version 5.2.x) 26