Quickie Jive 195.5 drive wheel suspension jive f/rThe Jive F/R has an effective and adjustable drive wheelsuspension system as a standard feature. To match yourrequirements on drive comfort, the tension of the springsat the damper can be adjusted.Turning the aluminium ring on the bottom of the springdownwards will soften your ride, adjusting the aluminiumring in a higher position will harden it. This option isto be used to match the different user weights to thesuspension system. (Fig. 5.7). We recommend thesuspension adjustments are done equally on the left andright side of the chair.5.6 control joystick unit positionDepending on your chosen control system, there are twoprinciples of control systems: Quickie VR2 and QuickieR-net controls (for details please see the controls section7). The remote is mounted on a sliding mechanismwhich enables the control to be moved forwards andbackwards.Undo the locking screw, (Fig.5.3).•Slide the control arm either out or to it’s new position,•(Fig.5.4).When the most comfortable position has been selected,secure the slider by tightening the locking screw. Ensurethe locking screw is fully tightened prior to use andespecially when transporting your wheelchair.5.7 arm rests5.7.1 arm rests-removingThe arm rests on both sides of the wheelchair can beremoved to allow side transfer.Please refer to your appropriate arm rest type.For single post arm rests:Undo the finger wheel at the bottom of the post,•(Fig.5.1).Lift the arm rest out of the receiver, (Fig.5.1).•Reclining arm rest:Undo the star wheel at the bottom pivot of the arm•rest.Lift the arm rest up out the receiver. You can now flip•it backwards, (Fig. 5.8).For F-XL and Recaro:Single Post Armrest:Release the handle screw on the side of the armrestreceiver and remove armrest (Fig. 5.8.1).5.7.2 arm rests-replacmentPlease refer to your appropriate armrest type.Single Post Armrest Jay- Jay Comfort:Place the armrest tube in the armrest receiver.•Fix and tighten the finger wheel, (Fig. 5.4).•Reclining armrest:Move the arm rest from the flip back position and placethe post into the receiver.Tighten the star wheel on the receiver to lock the postinto position, (Fig. 5.8).5.7.3 adjusting the armrest width (jay and jaycomfort seat only)To adjust the width:Loosen the four screws (13mm spanner) as shown in•(Fig. 5.9).Move the armrest receiver brackets to the desired•position, (Fig. 5.10).Tighten the screws firmly prior to use.•note: Please check that the new arm restposition does not interfere with any seat positioningmodules, Lift-Tilt etc.Fig.5.7Fig.5.8Fig.5.9 Fig.5.10Fig.5.8.1