Quickie Jive Instructions For Use Manual

Contents

Quickie Jive Instructions For Use Manual Manual pdf 53 page image

Quickie Jive 5314.7 how to connect the cables to the batterieswarnIng!If you are in any doubt about performing anymaintenance on your wheelchair, please contact yourSunrise Medical authorised dealer.parts in the battery box:Two 12v Deep Cycle Mobility Batteries.•Two Fused Battery Loom Assemblies.•One Power Loom•warnIng!Before connecting the batteries it is very important•to identify the correct connection for each batteryterminal. Failure to do this may result in thewheelchair not functioning or possibly a blown fuse.Connect all battery terminals before connecting the•plugs.After connecting battery terminals and connectors•ensure all wiring is tidy and can not get entangled inany moving parts and the rubber covers fit fully overthe battery terminals.note: After connection of the batteries wait 2 minutesfor the system to reset, before switching on the controlsystem. This reset time is required every time thebatteries are disconnected.connecting / disconnecting the batteries:Undo the two seat interface screws, (Section 12.1).•Flip the seat frame backwards until the automatic•lock pin clicks to secure it in place. Ensure the seatis secure before letting go, (Fig.14.21).Lift off the battery box lid, (Fig.14.22).•The Front battery has RED to Positive (+) & BLACK•to negative (-). (Fig.14.23 - 14.24).The Rear battery has RED to Positive (+) & BLACK•to negative (-). (Fig.14.23 - 14.24).Connect the GREY plugs to the power loom,•(Fig.14.25 - 14.26).warnIng!Ensure the two seat interface screws are fully tightenedbefore using the wheelchair, (Section 12.1, Fig.12.1).Fig. 14.21Fig. 14.22Fig. 14.24Fig. 14.25Fig. 14.26Fig. 14.23