Inserting Batteries in the RemoteRemote Control Reception Angle• Remove the cover of battery cabin on the back of the remote control by pushing the tab and sliding the cover.• Insert two AAA batteries, making sure the polarities (+ and -) are aligned correctly.• Place the cover back.• Are the polarities (+, -) correct?• Are the batteries worn out?• Is there an AC power failure?• Is the power cord plugged in?• Is there any interference or block near the remotecontrol sensor?Use your remote control within the distance and angle range shown below.If the remote control does not work, check these points:• Used batteries should be recycled.• Keep out of children’s reach.• DO NOT use new and old batteries together.• Change both the batteries at the same time.• When not using the remote control for a long time,remove the batteries from the unit.CAUTION:20 feetRemote Control Instructions18Universal Remote Control Code ListFor Universal Remote Control brands listed below, pleaseuse accompanying codes and refer to your UniversalRemote Control User Manual for basic Instruction forchanging TV code to operate the TV model.Codes for DIRECTV: 0178, 10178Codes for Time Warner Cable: 0178, 10178Codes for Cox Communications: 0178Codes for Comcast: 10178Codes for Dish Network: 627Codes for Fios Verizon: 0205, 0057, 0493, 0775