RCA 27F634T User Manual

Also see for 27F634T: Specifications

RCA 27F634T User Manual Manual pdf 13 page image

Go BackAuto Ch. Search ...List & Labels ...Closed Caption ...Favorite CH ...Language English...Auto. format 4:3SETUP< >Go BackSignal Source Both...Analog Sig. Type Cable...Digital Sig. Type Antenna...Start Running...Search percent 10Analog Channel 0Digital Channel 0AUTO CHANNEL SEARCH�Tuning to a ChannelAnalog station numbers display on your TV in a rectangle as you enter the numbers. You canenter digits to access a channel. In the example below, you can enter 12 or 012 to get thesame channel. To enter a one-digit channel, such as channel 8, just press 8. After entering thechannel, press OK. The CLEAR button on the remote clears all entries.Digital channels can have both primary channels (like the analog channel number) andsubchannels. Digital station numbers display in a larger rectangle that can contain up to eightnumbers. Numbers to the left of the - (dash) are the main channel number; numbers to theright are the subchannel numbers for stations that broadcast more than one signal.In the example to the left, press “1”, press “2” (although 012 is shown in the example,pressing “0” isn’t required) and then press the right arrow button to move to the subchannel.Press “1” and then “OK.” The TV tunes to channel 12-1. If channel 12 is broadcastingsubchannel signals, you would enter numbers that would access the other signals. (Example:12-1, 12-2, 12-3). If the selection times out, you must start over. Once you’ve made all entries,press OK. The CLEAR button on the remote clears all entries.Notes: You may experience a delay of several seconds before digital pictures appear,both when you first turn on the digital signals and when you change channels. This isnormal. Digital channels sometimes take longer to tune.Complete the Initial SetupAUTO CHANNEL SEARCH is the first menu you should see when you turn onthe TV. (It is located from this path Main Menu/Setup/Auto Ch Search). It allowsthe TV to search for all channels viewable through your digital and analogconnections. This is sometimes called auto programming.1. From the Auto Channel Search menu press the right arrow button to choosethe Signal Source (Digital, Analog, or Both). The default is Both.2. With the Signal Source chosen, press the down arrow button to select Startand press OK. AUTO CHANNEL SEARCH runs as it finds all the availablechannels. (This step might take 10-15 minutes depending on your contentprovider).3. Once the search is complete, you can begin watching TV. For informationon customizing your channels or menu options, go to Chapter 3.Note: After you complete the Auto Channel Search you may see anadditional screen. “Time stored in the TV may be incorrect after a loss ofpower. Please check the time in the Time menu” may appear, remindingyou that the time setting is incorrect. Go to page 35 for more information.Choose the Menu LanguageTo set the language, use the arrow buttons to highlight Language. The defaultlanguage is English. To choose another language, press the right arrow buttonon the remote, choose the language and press OK.Go BackAuto Ch. Search ...List & Labels ...Closed Caption ...Favorite CH ...Language English...Auto. format 4:3SETUP< >_12Analog channelexample entry012-1_ _Digital channelexample entryContinues on next page...Chapter 1 11Connections & Setup