Connecting Your TVUsing DC Power CordH,ow to Operate TV on DCPower (Car Battery)You can power your TV from a 12-volt car, truck, or RV battery byu',dng the. optional DC power cord.Instructions are below.1. Unplug the AC cord from thewall outlet.2. Unplug the AC cord from theback of your TV.. Plug the square end of the DCpower cord into the back of yourTV. (Use the same 4-prongoutlet for both the AC cord andthe DC power cord.) The plug isdesigned to fit only one way.Back of TV%..Plug the round end of the DCpower cord into an automobilecigarette lighter socket.Operate the TV the same way asyou would if the set were on ACpower.before use, :_<_ _ i 2 _ !! _ "_i:_i_iiOpe_tlon,:_):!:_:>:'?,:: _:>':i :cord, or similar.adapter mayresult in damage to, your 'IV.• Avoid u_g the-TV in a earunless the engine is turned onand running. Doing so willdrain the ear battery which maycause the carnot to start. properly,: ,:• Do not put the.'IV on the"dashboard, oi _leave it in a:earparked_ _sunlight Sinceth e temperature inside the car _.may damage the set.* If taking the TVfrom a cold carto a warm room, do not attemptto plug.in the :set ff there is anysiff,n of condensation. Thiscould d_€ the set.• Be _e liOt to block any of theventilation slots when the set isturned on. This may causeoverheating and damage the set.Replacing Fuse in DCPower CordThere is a safety fuse in the plug ofthe DC power cord. If the fuseblows out, follow the steps below toreplace it.1. Unscrew the end of the plug byturning it counterclockwise...When you remove the end, youwill see the fuse.Replace fuse with a new125-volt, 13-amp fuse such as#149823 (available from yourlocal dealer).Note: If the spring falls out of the plug,be sure to install it before you reattachthe end.4. Screw end (with new fuseattached) back on plug.2O