RCA E09303 Owner's Manual
                            | |
Contents
| 
Trouble ChecksYou may have problems that can be fixed with a few minor adjustments. Look for thetype of problem you are having below and then try the suggestions to get your TVgoing again. For warranty information see the back cover.TV TroubleTV will not turn onControls don't workIntermittent or no remoteTurns off while playingChecks and Adjustments• Check to make sure it is plugged in.• Check the wall receptacle (or extension cord) to make sure it is "live" by plugging insomething else.• Maybe batteries in remote are "dead". Try using POWER button on TV.• Maybe remote control was not aimed at remote sensor.• Make sure power cord is fully inserted into back of TV.• Try unplugging set for 15 minutes and then turning it on again.• Make sure power cord is fully inserted into back of TV.• Maybe something was between the remote and the remote sensor.• Maybe batteries in remote are weak or dead. Try replacing batteries.• Maybe batteries were installed incorrectly. Try replacing batteries correctly.• Sleep Timer function may have been activated.• If TV turned on because of alarm, it will automatically turn off after one hour.• Electronic protection circuit may have been activated because of a power surge. Wait30 seconds and then turn on again. If this happens frequently, the voltage in yourhouse may be abnormally high.• Make sure power cord is fully inserted into back of TV.Turns on unexpectedly • Alarm function may be turned on.Blank screen • Try another channel.• Maybe FM radio is selected. Try pressing DISPLAYbutton on the remote.No sound, picture okay • Maybe sound is muted. Try pressing VOL up button to restore sound.• If headphones are connected, sound from TV speakers will be muted................................... _....................................Can't select certain channel • Channel may not be in channel memory. Try using number buttons.• If using VCR, check to make sure TV/VCR switch on VCR is in correct position.• To select cable-TV channels over 99 (up to 125), press and hold number button 1 until1-- appears on the screen. Then press the other two numbers............................ _- .....................................No picture, no sound "If watching VCR (connected through antenna input), make sure "IV is tuned tochannel 3 or 4-same as CH3/CH4 switch on VCR. Also check to make sure TV/VCRswitch on VCR is in correct position.•Maybe FM radio is turned on but not tuned to an active station. Press DISPLAY onremote.Sound okay, picture poor •Check antenna connections.•Try adjusting SHARPNESS function to improve weak signals.24 |
Related manuals for RCA E09303
manualsdatabase
Your AI-powered manual search engine