RCA F20TF10 User Manual

Also see for TruFlat F20TF10: Brochure & specs

Contents

RCA F20TF10 User Manual Manual pdf 19 page image

Chapter 1 13Connections & SetupVCR03CHANNELCABLE BOXTipIf you don’t have both acable box and a VCRconnected to your TV,just coil the cable of theextra G-LINK wand witha twist tie and leave itbehind the TV.VCR03CHANNELSENSORSENSORConnect to G-LINK jackon the back of the TV.R L/ MONO VIDEOANTENNAS-VIDEOTV back panelOUTR LING-LINKG-LINK wandsG-LINK cableWhy You Should Connect This G-LINK CableThe G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide) towork with your VCR and/or cable box.Cable Box – If your TV is connected to a cable box you must connect the G-LINK cable to receiveTV program listings for your area, and to tune directly to a channel when the program guide is onyour TV screen.VCR – If your TV is connected to a VCR and you don’t connect the G-LINK cable, one-touch VCRrecording won’t work. The other features of the guide will work properly.How to Find the Remote SensorYou have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn’tlabeled on your VCR and/or cable box, you need to use the remote control that came with the VCRand/or cable box to locate the sensor.1. Turn off the VCR and/or cable box.2. Hold the remote control (not the one that came with your TV, but the one that came with thecable box and/or VCR to which you’re attaching the G-LINK cable) so that it is touching thefront of the component.3. Slowly move the remote control across the front of the component (VCR or cable box) whileyou press the power button on and off. You must press and release the power button each timeyou move the remote (holding down the button won’t work).4. When the component turns on, you’ve located the remote sensor.Placing the G-LINK WandsPlace the G-LINK wands in front of the remote sensor on your VCR and/or cable box approximatelyone inch away from the remote sensor (see instructions below).