RCA F20TF10 User Manual
Also see for TruFlat F20TF10: Brochure & specs
                                                                    | |
Contents
| 
Why You Should Use the G-LINK CableIf you require a cable box to supply your television signal, you must properly connect the G-LINK cable in orderto use the GUIDE Plus+ system. Additionally, using the G-LINK cable with your VCR enables one-touch VCRrecording from the on-screen program guide.How to Find the Remote Control SensorThe G-LINK wand needs to be placed in front of the remote control sensor on your VCR and/or cable box sothat the TV can communicate with each of these components.Some cable boxes and VCRs have the remote control sensor labeled on the unit. If the remote control is labeledon your VCR and cable box, skip to “Placing the G-LINK Cable Wands” below.If the remote control sensor isn’t labeled on your VCR and/or cable box, you need to use the remote control thatcame with the VCR and/or cable box to locate the sensor.1. Turn off the VCR and/or cable box.2. Hold the remote control (not the one that came with your TV, but the one that came with the cable boxand/or VCR) so that it is touching the front of the component.3. Slowly move the remote control across the front of the component (VCR or cable box) while you press thepower button on and off. You must press and release the power button each time you move the remote(holding down the button won’t work).VCR03CHANNELCABLE BOXVCR03CHANNELSENSORSENSORConnect to G-LINK jackon the back of the TVTipIf you are not using both ofthe G-LINK wands with yoursystem, you can coil the extracable, secure it with a twisttie, and leave it behind the TV.Placing the G-LINK Cable WandsPlace the wands of the G-LINK cable underneath your VCR and/or cable box so that thebulb is about one inch in front of the remote control sensor. (Make sure you have pluggedthe G-LINK cable into the G-LINK jack on the back of the TV.STEP 2: Place the G-LINK WandsThe G-LINK wands must be placed in front of the remote control sensors on your VCR and cable box toenable the GUIDE Plus+ system to work properly with your VCR and/or cable box.4. When the component turns on, you’ve located the remote control sensor.5. Place the wands of the G-LINK cable underneath your VCR and/or cable box in front of the sensor (seeinstructions below).G-LINK wandsG-LINK cableG-LINK wand G-LINK wand |
Related manuals for RCA TruFlat F20TF10
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine