Removing the Table StandYour TV comes with the table stand attached. If you want to mount your TV to the wall, remove the table standby following the instructions below.Step 1Place the plastic bag off the TV and place it on atable or other flat surface. Place the TV set facedown on the TV bag.Step 3 (Only for model L42FHD37R/L46FHD37R)Attach the stand cap to the TV cabinet.TV cabinet with stand cap attached.Connections and Setup Chapter 1 7Step 2Remove the table stand from the TV cabinet. Use ascrewdriver to remove the three M6 ST-screws.(Note: Formodel L46FHD37R, there are four M5 ST-screws. )1Mounting Your TV to the WallThe VESA number is the horizontal and vertical measurement of the mounting holes. For example, 600x400refers to fact that the mounting measurements are 600mm horizontally and 400mm vertically.Follow the directions included with the wall mount to mount the TV to the wall.Caution: Your wallmount must be able tobear a minimum of fivetimes the TV’s netweight to avoid causingdamage.To mount your TV to the wall, purchase a VESA wallModels L40FHD41/L42FHD37R/L46FHD37R Purchase a VESA 600 x400, Size M6 screwStep 3 (Only for model L40FHD41)Attach the stand cap to the TV cabinet using a M4ST-screw and a screwdriver.TV cabinet with stand cap attached.