RCA LCDX2722W User Manual

Also see for Scenium LCDX2722W: Specifications

Contents

RCA LCDX2722W User Manual Manual pdf 12 page image

Connections & Setup8 Chapter 1Graphics contained within this publication are for representation only.Connection to a Personal ComputerUsing RGBConnect a personal computer to the TV using the RGB jack. Connect a 15-pin monitor cable to thecomputer and the other end to the bottom of the TV.Note: Your computer will most likely output the signal in a 4:3 aspect ratio. Be sure tochange the monitor setting for the best picture quality.SUBWOOFEROUTR LAUDIOOUTAUDIO OUTPUTPlug in the TVPlug the flat end of the cable into the power jack on the bottom panelof the TV. Plug the end of the power cord into an appropriate walloutlet. Be sure to insert the plug completely. Do not plug into an outletcontrolled by a light switch.RGBAUDIOINPut batteries in the remote• Remove the battery compartment cover from the back of the remote by pushing down on thetab and lifting the cover.• Insert 2 fresh “AA” batteries. Make sure the polarities (+ and -) are aligned correctly.• Replace the cover.Turn on the TVPress TV on the remote, or press POWER on the TV’s side panel.Note: Pressing the TV button turns on the TV and puts the remote into TV mode. “TV mode”means that the buttons on the remote control operate the TV’s functions.Adjust the Viewing Angle of the TVThe TV’s screen is adjustable simply by pushing on the top, front part of the screen, while yourother hand holds the base of the TV.Set Up Your TVThere are several options you might need to set up in order for your TV to work properly. Turn onyour TV, then press the MENU button on your remote control. Read the instructions that follow.