PE Pipe PeelerPEPEEL6 Range: 1 1/2” - 6” nominal IPS PE (48 - 168 mm) 1.9” actual diameter or largerPEPEEL12 Range: 6” - 12” nominal IPS PE (168 - 324 mm) 6.6” actual diameter or largerStep 1 - With the blade up,place the peeler on the pipe andattach the chain.Step 2 - Orient the tool so thewheels align with edge of pipe.Then lightly tighten chain.Step 3 - Wrap the excess chainaround itself and attach the endwith the magnet or chain keeper.Lower the cutter.Step 4 - Rotate tool clockwiseuntil the pipe is peeled to thedesired length.Fig. 1: Before peeling, it may benecessary to score the outsidelayer of the pipe to ensure thechip breaks.NOTES: PE Pipe Peeler can be used anywherealong the pipe, provided there is 5 1/2” (142 mm)clearance for the PEPEEL6 and 6 1/2”(165 mm) clearance for the PEPEEL12.This application can be useful for electrofusionfor tapping saddles.• PE Pipe Peelers will work on metric pipe sizes.• PE Pipe Peelers remove .010” ribbon material.Because inner diameter depths differ from fittingto fitting, it is up to the operator to determineand then put sufficient peel length on the pipe inorder to properly electrofuse fittings to the pipe.Fig. 1Phone: 800-666-3691 or 814-452-3691Fax: 800-456-1697 or 814-455-1697www.reedmfgco.com1219R-54217Reed Manufacturing Company1425 West 8th StreetErie, PA 16502 USA132 Blade Assembly1 Screw #352412 Blade #245303 Blade Holder #98639Reed PE Pipe Peeler online videovideos.reedmfgco.com/peelerPEPEEL6, PEPEEL12#04632 Use of Chain KeeperLoosen thumb screw a few turns.Spread side plates and place overchain rivets and tighten thumb screw.Thumb Screw