REED True Peel Operating Instructions Manual

REED True Peel Operating Instructions Manual Manual pdf 1 page image

INSTRUCTIONSTrue Peel ® PE Prep Tool is designed to peel both the end of the pipeand Tapping Tees for electrofusion. Rotate the Feed Screw Knobclockwise until the mandrel is fully extended. Insert the Mandrel into thepipe. While holding down the Blade Lever, push the mandrel all the wayin until it reaches the small tapered section of the mandrel. Firmly pressthe mandrel into the pipe as far as possible to prevent the mandrel fromrotating inside the pipe. Rotate the Peeler Body clockwise one to twoturns and check to see if the end of the peel has not wedged betweenthe pipe and the inside of the peeler body. If so, simply pull the end ofthe peel out and continue rotating the peeler. Rotate the peeler until theend of the pipe can be viewed in the center of the observation window.The peel is complete. Hold down on the Blade Lever to raise the bladewhile pulling the peeler off the pipe.MANDREL REPLACEMENTEach Reed peeler comes with a specific mandrel size for wall thick-ness. For some body sizes, alternate mandrels are available to ac-commodate other SDR/DR wall thicknesses. To replace the mandrel,remove the guide and guide screw. Remove the mandrel screw. Holddown the blade lever and remove and replace the mandrel.For a full list of mandrel sizes, refer to www.reedmfgco.com.Reed Manufacturing Company1425 West 8th StreetErie, PA 16502 USAPhone: 800-666-3691 or 814-452-3691Fax: 800-456-1697 or 814-455-1697www.reedmfgco.com 0120-54633True Peel® PE Prep ToolsOperating InstructionsFEED SCREW KNOB BLADE LEVERBLADEMANDRELOBSERVATION WINDOWTAPEREDSECTIONOF MANDRELGUIDEPIPEPEELER BODY

/ 2

Related manuals for REED True Peel