Using The Instrument 3-9The command:VOLTage:OFFSet sets the offset for the currently active function. The default offset is0 V.The query:VOLTage:OFFSet?queries the output offset for the currently selected function andreturns a value in volts.Selecting the FilterTypeBefore selecting the filter type, use the following command toactivate the filter:OUTPut:FILTer { OFF | ON}ON enables the filter that has been selected with theOUTP:FILT:FREQ command. The default filter state setting is OFF.The query:OUTPut:FILTer?queries the output filter state and returns "0" (OFF) or "1" (ON).The command:OUTPut:FILTer:FREQuency {<20MHz | 25MHz |50MHz>}sets the filter frequency for the currently active function. 20 MHz hasa Gaussian response, and the 25 MHz and the 50 MHz filters havean Elliptical response. Note that the filters cannot be changed if thesynthesizer is set to output sine waveform from its standardwaveform library. The filters will be activated only after theOUTP:FILT ON command. The default filter setting is 20 MHz. Notealso that 20 MHz, 25 MHz and 50 MHz designate filter types. Theseparameters should be programmed as switches, not as values. Thefilter type cannot be programmed using OUTP:FILT:FREQ 25e6 orOUTP:FILT:FREQ 50e6 Hz.The query:OUTPut:FILTer:FREQuency?queries the currently selected filter setting and returns 20 MHz, 25MHz or 50 MHz.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
