RadioLink RC3S Instruction Manual

Also see for RC3S: Instruction manual

RadioLink RC3S Instruction Manual Manual pdf 18 page image

173.If initial MODE setup item is SPEED 2,{ if initial MODE setup item is SPEED 1,you need to select SPEED 2 by pressing “Dec(-)” or “Inc(+)” button to select MODEsetup item , then press “Enter” key, SPEED 1 or OFF will blink, press “Dec(-)” or“Inc(+)” button,when the blinking SPEED 1 or OFF change to blinking SPEED2,press “Enter” key,SPEED 2 will stop blinking, now SPEED 2 is selected}, press“Dec(-)” or “Inc(+)” button to select "LOW" or "HIGH" delay adjustment or“TGP1” Speed switching point adjustment.4.Press “Enter” key to confirm "LOW" or "HIGH" or “TGP1” setup item, and thevalue of your selected setup item will blink. Use “Dec(-)” or “Inc(+)” button to adjustthe value.(Note: In the interface of adjusting the value, return to the initial value （the initialvalue of LOW and HIGH is “100”, the initial value of TGP1 is “30”） by pressing“Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)Press “Enter” button, the adjusted value stops blinking, now your selected value hasbeen set.5.When ending setting, return to the initial screen by pressing “Exit” button twice.Pulse brakeWhen the brakes are applied while cornering with a 4 Wheel Drive or other type ofvehicle, understeer may occur. The generation of understeer can be eliminated andcorners can be smoothly cleared by using this function.Operation- When the brakes are applied, the throttle servo will pulse intermittently. This willhave the same effect as pumping the brakes in a full size car.- The brake return amount, pulse cycle, and brake duty can be adjusted.- The region over which the ABS is effective can be set ac-cording to the steeringoperation. (Mixing function)Setup itemsABP: Brake return amountA.B.S. Function "A.B.S"