PROGRAMMING OF VRAE4 - 314.7.3 Change User ModeThere are three different user modes: text, display, andprogram in VRAE that can be selected from theprogramming menu.1. “Change User Mode?” is the fourth sub-menu item inTable 4.6.2. Press the [Y/+] key, the display shows the current usermode selection: “User Mode = Program?”3. Press the [Y/+] key to accept the currently displayed usermode. Press [N/-] key to scroll through the other twouser modes. Press [MODE] key to exit this sub-menuand move to the next monitor setup sub-menu.4. If there is any change to the existing selection, pressingthe [Y/+] key the display will show “Disable Program!Are you Sure?” Then, press the [Y/+] key to accept or the[N/-] key to discard and move to the next sub-menu.Caution: If the user mode is changed to display mode, theuser can no longer enter the programming menu. Therefore,the user cannot change the user mode back to programmode from the monitor. The only way to change the usermode back to “program” mode is to use a PC and theProRAE-Suite program or Turn on unit in diagnosticmode and then enter the program mode by enteringcorrect password (see Section 5 for details).
