Rangemaster Classic 110 Deluxe Duel Fuel Users Manual & Installation

Also see for Classic 110 Deluxe Duel Fuel: User guide User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

32WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.Conversion to LP gasCheck in the Technical Data section atthe back of the book that the cooker isconvertible to the gas you want to use.This conversion must be performed by a competentperson. After conversion the installation must complywith the relevant regulations and also the localelectricity supply company requirements. Read theinstructions before converting this appliance.Failure to convert the appliance correctly couldinvalidate any warranty or liability claims and lead toprosecution.This instruction must be used in conjunction withthe rest of the appliance instruction, in particularfor information on Standards, cooker positioning,connection hose suitability etc.When servicing or replacing gas-carryingcomponents disconnect from gas beforecommencing operation and check appliance is gassound after completion.Do not use re-conditioned or unauthorised gascontrols.Disconnect from the electricity supply beforecommencing servicing. Before electrical re-connection, check that the appliance is electricallysafe.InjectorsRemove burner caps and heads. Remove old jets. Fit thenew jets (see Technical Data section at the back of thebook for correct jets). Reassemble in reverse order.Tap adjustmentDisconnect from electricity supply.Pull off all the control knobs.Open the grill and right hand oven doors and removethe 4 fi xing screws underneath the control panel.Remove the handrail by removing the 2 end bracketfi xing screws.Remove the 2 cross-headed screws that were hidden bythe handrail end brackets.The control panel should drop down slightly. It is heldat the top by two holes in the top edge one at each endthat locate on tags on the inner panel.Clear the holes from the inner panel and pull the controlpanel forward.Take care not to damage or strain the wiring.To convert to LP gas.Turn the bypass screw on each control clockwise to thestop.Refit the control panel. Locate the holes in the top edgeon the tags on the inner panel and replace the fixingscrews in the bottom edge.Replace the hand rail.