Rangemaster Elise SE 110 User's Manual & Installation Instructions

Also see for Elise 110 Dual Fuel: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Rangemaster Elise SE 110 User's Manual & Installation Instructions Manual pdf 25 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.21ArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloor3 mm minTypical floor mountingArtNo.010-0004 Moving the cookerFig.7-5Fig.7-6Moving the Cookernn On no account try and move the cooker while it isplugged into the electricity supply.nn The cooker is very heavy, so take great care.We recommend that two people manoeuvre the cooker.Make sure that the floor covering is firmly fixed, or removed,to prevent it being disturbed when moving the cookeraround.To help you, there are two levelling rollers at the back, andtwo screw-down levelling feet at the front.Remove the polystyrene base pack. From the front, tiltthe cooker backwards and remove the front half of thepolystyrene base (Fig.7-4). Repeat from the back and removethe rear half of the polystyrene base.Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjustingnut (Fig.7-5). Rotate the nut – clockwise to raise – counter-clockwise to lower.Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the cardboard base tray. Open theoven doors so that you can get a good grip on the bottom ofthe fascia panel as you move the oven (Fig.7-6).Carefully push the cooker backwards off the base tray.Remove the base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn DO NOT use the door handles or control knobs tomanoeuvre the cooker.Fitting the Stability Bracket or ChainUnless otherwise stated, a cooker using a flexible gasconnector must be secured with a suitable stability device.Suitable stability devices are shown in Fig.7-7, Fig.7-8 andFig.7-9.If you are using a stability chain (Fig.7-7) then the chainshould be kept as short as is practicable and fixed firmly tothe rear of the cooker.If you are using a stability bracket (Fig.7-8 and Fig.7-9), thenadjust the bracket to give the smallest practicable clearancebetween the bracket and the engagement slot in the rear ofthe cooker.Fit the bracket so that it engages as far as possible over thechassis of the cooker.Fig.7-7Fig.7-8Stability chainCookerOuter stabilitybracketFloorWall3 mm minTypical wall mountingFig.7-9