Rangemaster Elise SE 110 User's Manual & Installation Instructions

Also see for Elise 110 Dual Fuel: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Rangemaster Elise SE 110 User's Manual & Installation Instructions Manual pdf 29 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.25ABCArtNo.311-0010 InjectorsFig.8-1A – Jet, B – Internal injector, C – External injectorGrub screwGrub screwFig.8-2ArtNo.255-0015 - 110DF - Elise removing the control panelB BA A A01001401802200 0 0 0 0 0 01001401802200Fig.8-3Check the ‘Technical Data’ section at the back of the bookthat the hob is convertible to the gas you want to use.A suitably competent person must perform the conversion.After conversion the installation must comply with therelevant regulations and the local electricity supply companyrequirements. Read the instructions before converting thisappliance.nnFailure to convert the appliance correctly couldinvalidate any warranty or liability claims and leadto prosecution.nn When servicing or replacing gas-carryingcomponents disconnect from the gas supply beforestarting operation. Check the appliance is gas soundafter completion.nn DO NOT use reconditioned or unauthorised gascontrols.nn Disconnect from the electrical supply beforeservicing. Before electrical reconnection, check theappliance is electrically safe.InjectorsRemove the burner caps and heads. Remove the old jets(Fig.8-1). Fit the new jets (see the ‘Technical Data’ section at theback of the book for correct jets). Reassemble in the reverseorder.Tap AdjustmentRemoving the Control PanelPull off all the control knobs. Using a 2.5 mm Allen key,undo the 2 retaining screws in the base at each end of thehandrail and remove (Fig.8-2). Using a 2 mm Allen key, undothe 2 retaining screws in the base and side of each handrailsupport and remove.Remove the 3 fixing screws (A) from the underside of thecontrol panel (Fig.8-3). Remove the 2 screws (B) that werehidden by the handrail supports. Lift the control panel clear,taking care not to damage or strain the wiring.Bypass Screw AdjustmentTurn the bypass screw on each control clockwise to the stop(Fig.8-4).Refit the control panel. Locate the holes in the top edge onthe tags on the inner panel and replace the fixing screws inthe bottom edge.Stick on LabelStick the LP gas label over the natural gas part of theappliance data label.8. Conversion to LP GasArtNo.0102-0011 - Screwingthe control valve bypass screwFig.8-4