Rangemaster Elise SE 110 User's Manual & Installation Instructions

Also see for Elise 110 Dual Fuel: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Rangemaster Elise SE 110 User's Manual & Installation Instructions Manual pdf 28 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.24ArtNo.281-0026 - Front plinthFig.7-15Electrical ConnectionThe cooker must be installed by a qualified electrician, inaccordance with all relevant British Standards/Codes ofPractice (in particular BS 7671), or with the relevant nationaland local regulations.Note: The cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker, througha suitable cooker control unit incorporating a double-poleswitch, having a contact separation of at least 3 mm in allpoles.nn The cooker MUST NOT be connected to an ordinarydomestic power point.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connect themains cable to the correct terminals for your electrical supplytype (Fig.7-13). Check that the links are correctly fitted andthat the terminal screws are tight. Secure the mains cableusing the cable clamp.Final ChecksHotplate CheckCheck each burner in turn (refer to the ‘Hotplate Burners’section at the front of the instructions).Grill CheckTurn on the grill control and check that the grill heats up.Oven CheckTurn on the ovens. Check that the oven fans start to turn andthat the ovens start to heat up.Note: The oven light bulb is not included in the guarantee.Turn off the ovens.Final FittingFitting the Pan SupportsPlease note that the outer pan supports are handed, and mayprevent the centre pan supports from fitting correctly. Thereis a small indent in the rear of each of the outer supports.This indent should be towards the outer edge of the cooker(Fig.7-14).Fitting the PlinthLoosen the 3 screws along the front bottom edge of thecooker. Hook the central keyhole over the central screw. Twistand fit each end keyhole over their respective screws. Tightenthe fixing screws (Fig.7-15).Customer CareInstaller: Please complete your details in this guide, informthe user how to operate the cooker and hand over theinstructions.Thank you.ArtNo.130-0010 Electrical connections single-phaseLN230 V ac 50 Hz10 mm² max6 mm² maxFig.7-13Current Operated Earth Leakage BreakersThe combined use of your cooker and other domesticappliances may cause nuisance tripping, so werecommend that the cooker is protected on an individualRCD (Residual Current Device) or RCBO (Residual CurrentBreaker with Overload).IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIEDELECTRICIAN.Fig.7-14