Rangemaster Longstock 90 Induction User's Manual & Installation Instructions

INSTALLATIONCheck the appliance is electrically safe when you have finished.28ArtNo.070-0014 - Stability bracket - Wall fittingCookerStabilitybracketFloorStabilitylocationbracketWallTypical wall mountingArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloorStabilitylocationbracketTypical floor mountingAlternative positionsfor stability locationbracketArtNo.010-0004 Moving the cookerLowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjusting nut(Fig. 8.5).Rotate the nut – clockwise to raise – counter-clockwise tolower. Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the cardboard base tray. Open thegrill door and right-hand oven door so that you can get agood grip on the bottom of the fascia panel as you move theoven (Fig. 8.6).Carefully push the cooker backwards off the base tray.Remove the base tray.Position the cooker close to its final position, leaving justenough space to get behind it Fig. 8.7).n DO NOT use the door handles or control knobs tomanoeuvre the cooker.Fitting the Stability BracketWe recommend using a stability bracket; first attach thebracket location device to the rear of the cooker (Fig. 8.8).Then adjust the bracket to engage through the slot of thedevice (Fig. 8.9 and Fig. 8.10).Repositioning the CookerFollowing ConnectionIf you need to move the cooker once it has been connected,make sure it is switched off at the supply switch beforegripping under the fascia panel and lifting the front of thecooker slightly (Fig. 8.6). Check behind the cooker to makesure that the electricity cable is not caught. As you progress,always make sure that the cable has sufficient slack to allowthe cooker to move.When you replace the cooker, check behind it again oncemore to make sure that the electricity cable is not caught ortrapped.Levelling the CookerPlace the cooker in its intended position. Take care notto twist it within the gap between the kitchen units, asotherwise, damage may occur to the cooker or units.There are two screw-down feet at the front and two levellingrollers at the rear, which can be used to adjust the height andlevel of the cooker.It is recommended that you use a spirit level on a shelf in oneof the ovens to check for level.Fig. 8.5Fig. 8.6Fig. 8.7Fig. 8.8Fig. 8.9Fig. 8.10