Rangemaster Professional + FX Dual Fuel User Manual & Installation & Service Instructions

16ArtNo.311-0013 Burner layout��Isolate the electricity supply before carrying out any majorcleaning. Allow the cooker to cool.Never use paint solvents, washing soda, caustic cleaners,biological powders, bleach, chlorine based bleachcleaners, coarse abrasives or salt. Do not mix differentcleaning products – they may react together withhazardous results.All parts of the cooker can be cleaned with hot soapy water– but take care that no surplus water seeps into theappliance.We have developed a range of cleaning products that givemaximum performance without damaging the enamel andpainted surfaces, in particular a Ceramic Hob Cleaner setwith scraper. More information is available through either theCookware Collection brochure supplied with your cooker or ourwebsite www.rangemastercookshop.co.uk.Remember to switch the electricity supply back on and resetthe clock before reusing the cooker.Daily CareCleaning the cooker is not a welcomed chore, but it has to bedone to maintain efficiency and appearance. Remember itis better to wipe up any spills as they occur, this will preventthem burning on and becoming more difficult to removelater. Make sure the flow of combustion and ventilationair to the cooker is unobstructed – for example bybuild-up of fats or grease.On Natural Gas the burners flames should be a bluish colourwith, at most, a slight yellowish fringe.On LP gas the flames may be “softer”. The cooktop burnerflames may have a slight yellowish tip.If the flame burns with a long white tip you should call forservice.Cleaning for SpillsFor spills and boil-overs that occur while cooking, turn off theburner as soon as possible and allow it to cool. Do not cleanuntil the area is completely cooled down. Wipe up spills assoon as possible.Do not allow surplus water to seep into the cooker.Hotplate BurnersThe burner heads and caps can be removed for cleaning.Make sure they are absolutely dry before replacing.The Single Ring BurnersWhen refitting the burner head, ensure that the notch linesup with the electrode or hole in the base. Check that theburner head is level and that the cap is fitted centrally on theburner head (Fig.6-1).6. Cleaning Your CookerFig.6-1A - Cap, B - Head, C - Notch, D - Electrode, E - Base