Rangemaster Professional + FX Dual Fuel User Manual & Installation & Service Instructions

22ArtNo.010-0004 Moving the cookerArtNo.092-0002 - 90 single cavity - Stability bracket fittingA100 mmC D550 mm550 mmBBRemoving the Oven DoorTo remove the oven door, open the door fully. Swivel thelocking ‘U’ clips forward to the locking position (Fig.7-5). Gripthe sides of the door, lift upwards and then slide the doorforwards (Fig.7-6).When you have removed the oven door continue as follows:First fit the levelling tool on the hexagonal adjusting nut(Fig.7-7).Make 10 complete (360°) turns clockwise (Fig.7-7). Thismeans turning and removing the levelling tool 20 times.Completing the MoveUnfold the rear edge of the pack base tray. Grip the fasciapanel and lift the front of the cooker slightly (Fig.7-8).Carefully push the cooker backwards off the pack base.Remove the pack base. Position the cooker close to its finalposition, leaving just enough space to get behind it.DO NOT use the control knobs to manoeuvre the cooker.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position, taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker. To adjust the height of the rear of the cooker use thelevelling tool supplied to turn the adjusting nuts at the frontbottom corners of the cooker. To set the front feet turn thebases to raise or lower.Leave the levelling tool in the storage drawer, so that thecustomer can use it if they wish to move the cooker.Fitting a Stability BracketA stability bracket or chain (not supplied by with the cooker)should be fitted when the cooker is connected to a flexiblegas supply.When fitting a stability bracket read these instructionstogether with the leaflet supplied with the bracket.1. Place the cooker in its intended position and level thecooker.2. Draw a pencil line 70 mm from the front edge of thelevelling feet (Fig.7-9).3. Mark the centreline for the bracket by measuring550 mm from the left-hand side of the cooker.4. Lower the front roller and move the cooker forward.5. Measure back from the pencil line 550 mm to locate thefront edge of the bracket (Fig.7-9). Fix the bracket tothe floor.6. Measure the height from floor level to engagementedge in back of cooker. Add 3 mm to this dimension andassemble the stability bracket to this height (i.e. fromArtNo.010-0010 Lowering the rear rollers (90)x10��Fig.7-6Fig.7-7Fig.7-8Fig.7-9A - Wall face, B - Rear rollers, C - Front levelling feet,D - Pencil datum lineArtNo.062-0001 - 90 Prof+ FX - Removing the doorFig.7-5