Rangemaster Professional + FX Dual Fuel User Manual & Installation & Service Instructions

17ArtNo.311-0014 Wok burner details��ArtNo.311-0016 Fitting the burner inner head��Fig.6-2Fig.6-4The Wok BurnerWhen reassembling the wok burner (Fig.6-2) turn over thelarge base ring and find the ‘D’ shaped area (Fig.6-3). Turn thehead until the ‘D’ matches the one on the burner base. Flipthe burner over once again and place it on the burner base.To fit the small inner burner, find the larger electrode notchin the burner rim. Line this up with the ignition electrode andplace the inner burner on the large base ring (Fig.6-4).Now fit the two burner caps, ensuring that they are seatedproperly.Check the burner ports are not blocked. If a blockage occurs,remove stubborn particles using a piece of fuse wire.GriddleAlways clean the griddle after use. Allow it to cool completelybefore removing. Immerse the griddle plate in hot soapywater. Use a soft cloth or, for stubborn stains, a nylon washingup brush.If the griddle is washed in a dishwasher then somedishwasher residue may appear on the back. This is normaland will not affect the performance of your griddle.The Wok CradleRecommended cleaning materials are hot soapy water, amoistened soap pad, cream cleaner or nylon scourer.Oven and DividerClean the oven and divider with a proprietary oven cleaner,suitable for enamel.IMPORTANT: Before cleaning the divider make sure toremove the silicon sealing strip from the front edge – someoven cleaners can damage the seal. Remove the strip bygently pulling both ends to release the hooks holding it inplace.Control Panel and Oven DoorsAvoid using any abrasive cleaners including cream cleaners,on brushed stainless steel surfaces. For best results use liquiddetergents.The control panel and control knobs should only be cleanedwith a soft cloth wrung out in clean hot soapy water – buttake care that no surplus water seeps into the appliance. Wipewith a clean dampened cloth then polish with a dry cloth. Theoven doors should only be cleaned with a soft cloth wrungout in clean hot soapy water.A - Inner burner cap, B - Outer burner cap, C - Inner burner head,D - Outer burner head, E - Wok burner baseArtNo.311-0015 Burner alignment��Fig.6-3A - Electrode notch, B - Ignition electrode