Rangemaster Toledo 110 Ceramic User Manual

Also see for 110 Ceramic: User guide User guide User's guide & installation instructions User's guide & installation instructions

Rangemaster Toledo 110 Ceramic User Manual Manual pdf 27 page image

INSTALLATIONCheck the appliance is electrically safe when you have finished.25ArtNo.342-0002 - Elan - drawer positionRemoving the Storage DrawerPull the drawer out to its furthest point (Fig.7-5).Lift up the ends of the plastic clips (one each side) to releasethe catches holding the drawer to the side runners and at thesame time pull the drawer forward and away from the siderunners (Fig.7-6).For safety’s sake push the drawer runners back out of the wayand put the drawer somewhere safe until the installation iscomplete.Now LOWER THE TWO REAR ROLLERS. First fit the levellingtool on the hexagonal adjusting nut, at both the front bottomcorners of the cooker (Fig.7-7). Make 10 complete (360°)turns clockwise (Fig.7-8). (This means turning and removingthe levelling tool 20 times.)Completing the MoveUnfold the rear edge of the pack base tray. Open the grilldoor and right-hand oven door so that you can get a goodgrip on the bottom of the fascia panel as you move thecooker.Grip under the fascia panel and lift the front of the cookerslightly (Fig.7-9).Carefully push the cooker backwards off the pack base.Remove the pack base tray. Position the cooker close to itsfinal position, leaving just enough space to get behind it. DO NOT use the door handles or control knobs tomanoeuvre the cooker.Repositioning the Cooker followingConnectionIf you need to move the cooker once it has been connected,make sure it is switched off at the supply switch beforegripping under the fascia panel and lifting the front of thecooker slightly (Fig.7-9). Check behind the cooker to ensurethat the electricity cable is not caught. As you progress,always ensure that the cable has sufficient slack to allow thecooker to move.If a stability chain is fitted, release it as you ease the cooker out.Do not forget to refit it when you replace the cooker.When you replace the cooker, check behind it again oncemore to ensure that the electricity cable is not caught ortrapped.ArtNo.010-0010 Lowering the rear rollers (90)x10Fig.7-6ArtNo.010-0002 Rear roller nutArtNo.010-0004 Moving the cookerFig.7-9Fig.7-7Fig.7-8