Rangemaster Toledo 110 Ceramic User Manual

Also see for 110 Ceramic: User guide User guide User's guide & installation instructions User's guide & installation instructions

Rangemaster Toledo 110 Ceramic User Manual Manual pdf 29 page image

INSTALLATIONCheck the appliance is electrically safe when you have finished.27Electrical ConnectionThe cooker must be installed by a qualified electrician, inaccordance with all relevant British Standards/Codes ofPractice (in particular BS 7671), or with the relevant nationaland local regulations.Current Operated Earth Leakage BreakersThe combined use of your induction cooker and otherdomestic appliances may cause nuisance tripping, so werecommend that the cooker is protected on an individualRCD (Residual Current Device) or RCBO (Residual CurrentBreaker with Overload).IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIEDELECTRICIAN. WARNING: THE APPLIANCE MUST BE EARTHED.Note: The cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker, througha suitable cooker control unit incorporating a double poleswitch, having a contact separation of at least 3mm in allpoles. The cooker MUST NOT be connected to an ordinarydomestic power point.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for your electricalsupply type (Fig.7-11 and Fig.7-12). Check that the links arecorrectly fitted and that the terminal screws are tight. Securethe mains cable using the cable clamp.Hob CheckCheck each cooking zone in turn. Be sure to use pans of thecorrect size and material.Grill CheckTurn on the grill control and check that the grill heats up.Oven CheckSet the clock as described earlier, and then turn on the ovens.Check the oven fans start to turn and that the ovens heat up.Fitting the Handles and Handrail(depending on model)Remove the 4mm Allen screws from the doors (Fig.7-13). Fitthe door handles and secure using the 4mm screws. The handles should be above the fixings.Fit the plastic blanking plugs to the fixing holes (Fig.7-14).Remove the 4mm Allen screws from the top corners of thefascia (Fig.7-15). Fit the front handrail in position and secureusing the 4mm screws.ArtNo.130-0010 Electrical connections single-phase��ArtNo.130-0010 Electrical connections 3-phase��Fig.7-11Fig.7-12ArtNo.215-0026 - Handle gaskets fixedArtNo.215-0027 - Elan handle blanking plugsArt No 215-0028 - Handrail fascia fixingsFig.7-13Fig.7-14Fig.7-15