Ransomes Spider ILD02 Safety, Operation & Maintenance Manual

GB-43SAFETY, OPERATORS & MAINTENANCE MANUAL14 WARRANTYWarranty conditionsThis document sets out the extent, conditions and manner of exercising rights stemming from theManufacturer’s liability for defects of the delivered Product1. Dvoøák – svahové sekaèky Ltd., registered office Dvorce 62, Havlíèkùv Brod 58001, Czech Republic, IDNo. 2601379 (further referred to as “Manufacturer”) provides a Warranty for new Products according to theset regulations for a period of 24 months from the day the Product is delivered to the Customer, or fromsuch a Product being set into operation, or up to 800 operating hours, according to whichever happensfirst. The Warranty period for new spare parts delivered under Warranty expires together with theWarranty period of the whole Product/machine.2. Claims stemming from the Warranty must be exercised with the Distributor / Dealer and also resolved bythem. A properly completed Warranty sheet must be presented and all of the inspections prescribed bythe Manufacturer must have been implemented. Incorrect information, additional extracts or overwriting onthe Warranty card lead to loss of the Warranty.3. The Warranty applies to defects on the Product caused by defective raw materials, construction faults ormade workmanship. Defective parts on the Product will be replaced free of charge with a new part orrepaired. No entitlement to immediate delivery is created and the Manufacturer takes on no liability fordamage claimed for as a result of delayed delivery.4. The Warranty does not relate to regular wear and tear (parts susceptible to regular wear and tearespecially include the following: blades, blade hubs with bearings, bearings of wheel shafts, spark plugs,air filters, belts, chains, tires, sealing, hydraulic hoses, winch rope etc…).5. The Warranty cannot be claimed against if the cause of the defect is:a) The effects of external mechanical or chemical influences on the Productb) Unreasonable handling of the Product, overloading it, neglect or incorrect operationc) Repair of maintenance of the Product performed by a third party, which was not authorised to carry outsuch work by the Distributor / Dealer or Manufacturerd) Installation of such parts into the Product, the use of which is not approved by the Manufacturere) Implementation of changes to the Product, which were not approved by the Manufacturerf) The fact that the Manufacturer’s regulations were not adhered to for handling the Product, itsmaintenance and treatment (e-g. the instruction and maintenance manual), especially if the prescribedWarranty inspections were not carried outg) The fact that the user neglected declaration and removal of defects, which were apparent when they tookreceipt of the Product or which they did not immediately provide notification of an have removed, whenthey arose later6. In case of Products sold with a discount the Warranty does not extend to defect for which the discountwas granted.7. All claims stemming from the Warranty are forfeit on expiry of the Warranty period. In the case of defects,for which notification was made during the course of the Warranty period and which were not removedduring this period, this Warranty remains valid until the defect is removed. In this case, the Warranty isterminated at the latest within 1 month of the last repair or after declaration by the Distributor / Dealer thatthe defect was removed or that this does not concern a defect.8. The Manufacturer is not liable for any economic loss or for any subsequent damage caused to persons ortheir property, which was created as a result of failure of the Product.9. The Warranty will only be valid subject to the condition that the correctly completed part 2 of the“Combined delivery note” is delivered to the Manufacturer within 14 days of the date the Product isdelivered to the Customer.10. The Warranty applies to the Product in the condition in which it leaves the production plant. TheManufacturer is not liable for damage during transportation.11. In the event of a change in owner, it is possible to transfer the remaining part of the Warranty period tothe new owner if the Manufacturer is requested to do so. The new owner confirms that they have takenreceipt of the instruction manual at the same time as the Product as well as the Warranty conditions andthat they agree with these.