Chapter 2: Installation and Configuration14E. Target Server PortsThe Dominion KX II uses standard UTP cabling (Cat5/5e/6) to connect toeach target server. See Specifications (on page 254) for additionalinformation.To connect a target server to the Dominion KX II:1. Use the appropriate Computer Interface Module (CIM). SeeSupported CIMs and Operating Systems (Target Servers) (onpage 257) for more information about the CIMs to use with eachoperating system.2. Attach the HD15 video connector of your CIM to the video port ofyour target server. Ensure that your target server's video has alreadybeen configured to a supported resolution and refresh rate. For Sunservers, also ensure that your target server's video card has beenset to output standard VGA (H-and-V sync) and not composite sync.3. Attach the keyboard/mouse connector of your CIM to thecorresponding ports on your target server. Using a standard straight-through UTP (Cat5/5e/6) cable, connect the CIM to an availableserver port on the back of your Dominion KX II device.Note: The DCIM-USB G2 provides a small slide switch on the back of theCIM. Move the switch to P for PC-based USB target servers; move theswitch to S for Sun USB target servers.A new switch position takes effect only after the CIM is power-cycled. Topower-cycle the CIM, remove the USB connector from the target serverand plug it back in a few seconds later.Step 2: Dominion KX II Initial ConfigurationThe first time you power up the Dominion KX II device, there is someinitial configuration that you need to perform through the Dominion KX IILocal Console:• Change the default password.• Assign the IP address.• Name the KVM target servers.
