Raritan PX3TS Quick Setup Manual

Also see for PX3TS: Quick setup guide User guide User guide User guide Quick setup guide

Contents

PX3TS Transfer Switch Quick Setup Guide 9QSG-PX3TS-0D-v3.1-E  255-80-0032-00 RoHSWhether to Use this commandMake theconnectionsuccessful byignoring the"incorrect"system timenetwork wirelessallowConnectionWithIncorrectClock = true or falsed. To determine which IP protocol (IPv4 or IPv6) isenabled and which IP address (IPv4 or IPv6) returnedby the DNS server is used, configure the followingparameters.To set Use this commandIP protocol network ip proto = v4Only, v6Only or bothIP addressreturned by theDNS servernetwork ip dnsResolverPreference = preferV4 or preferV6e. After enabling the IPv4 or IPv6 protocol in the earlierstep, configure the IPv4 or IPv6 network parameters.To set Use this commandIPv4configurationmethodnetwork ipv4 ipConfigurationMode = dhcp (default) or staticIPv6configurationmethodnetwork ipv6 ipConfigurationMode = automatic (default) or static Configure the preferred host name for the IPv4DHCP or IPv6 automatic configuration.Note: The variable in all of the followingcommands is either ipv4 or ipv6, depending on the typeof the IP protocol you have enabled.To set Use this commandPreferred hostname (optional)network preferredHostName = preferred host nameTip: To override the DHCP-assigned DNS servers withthose you specify manually, type this command:network overrideDNS where enable or disable. See the tablebelow for the commands for manually specifying DNSservers. For static IP configuration, configure theseparameters.To set Use this commandStatic IPv4 orIPv6 addressnetwork ipAddress address> = static IP addressIPv4 subnetmasknetwork ipv4 subnetMask = subnet maskIPv4 or IPv6gatewaynetwork gateway address> = gateway's IP addressIPv4 or IPv6primary DNSservernetwork primaryDNSServer = IP address of the primaryDNS serverIPv4 or IPv6secondary DNSserver (optional)network secondaryDNSServer = IP address of thesecondary DNS server9. To quit the configuration mode, type either of the followingcommands, and press Enter.Command Descriptionapply Save all configuration changes and exit.cancel Abort all configuration changes and exit.The # prompt appears, indicating that you have quit theconfiguration mode.10. To verify whether all settings are correct, type thefollowing commands one by one.Command Descriptionshow network Show network parameters.show network ip all Show all IP configurationparameters.

/ 10

Related manuals for Raritan PX3TS