Raritan Paragon switch Installation And Operation Manual

Also see for Paragon Manager: User manual

CHAPTER 2: I NSTALLATION 33Connecting a MasterConsole II (Model MCC only) as a TierSet MasterConsole II as a Tier Device:1. When powering ON, press and hold the Channel # 2 button on the front panel ofMasterConsole II for three seconds. This sets the MasterConsole II as a second-tier device.2. The LED on the far right of the unit’s front panel (second from right for MasterConsole Cmodels) will be lit steadily.Connect MasterConsole II to the Paragon Switch:If using a CIM UKVMC:1. Use a CCPnn cable to connect keyboard, monitor, and mouse connectors to user ports onMasterConsole II.2. Connect DB25 connector to UKVM.3. If using the user port of a MasterConsole X model for second-tier connection:a. Connect a RKVM module to the MasterConsole X model with a CVnn cable.b. Connect a CIM cable to keyboard, monitor, and mouse ports of RKVM module.4. Connect a Category 5e UTP cable to the CIM.5. Connect the other end of the Category 5e UTP cable to the channel port reserved on the baseParagon switch.If using a CIM UKVMP:1. Connect keyboard, monitor, and mouse cables to MasterConsole II user port.2. If using the user port of a MasterConsole X model for second-tier connection:a. Connect a RKVM module to the MasterConsole X model with a CVnn cable.b. Connect a CIM cable to keyboard, monitor, and mouse ports of RKVM module.3. Connect a Category 5e UTP cable to the CIM.4. Connect the other end of the Category 5e UTP cable to the channel port reserved on the baseParagon switch.Perform Channel Configuration:1. At a User Station Login Menu, type “admin” in the User Name field and press <Enter>.2. Type “raritan” (all lowercase) in the Password field and press <Enter>.3. Press <F5> to go to the Administration Menu, then select the Channel Configurationsubmenu.4. Use the <Ç> and <È> or the <Page Up>and <Page Down> keys to select the channel inwhich MasterConsole II is connected.5. Use the <Tab> key to advance to the Device field and change the device type to aMasterConsole II (MasterConsole II-4, MasterConsole II-8, MasterConsole II-16).6. Hold the <Shift> key and press <Tab> to go back to the Name column.7. Press <Enter> and edit the default name.8. Press <S> to save the new configuration.