Raven AutoBoom XRT Series Installation Manual
Also see for AutoBoom XRT: Calibration & Operation ManualInstallation manualInstallation manualInstallation manual
                                                                | |
Contents
| 
2016-0236-001 Rev. C 7INTRODUCTIONINSTALLATION OVERVIEWThe image below shows approximate installation locations for the sensor and nodes. Depending on machineconfiguration and desired performance some of the sensors and dampers may not be installed.FIGURE 2. Example Component LocationsFor additional information on the component installation, refer to the:• Rotary sensor installation instructions in “Center Rack Rotary Sensor Installation” on page 28.• Variable damper installation instructions in “Optional Damper Installation” on page 21.• REM node installation instructions in “Mount the AutoBoom XRT Valve” on page 15.• ABM node installation instructions in “Autoboom ABM Node Installation” on page 35.• Tilt sensor installation instructions in “Left and Right Tilt Sensor Installation (90’ and 100’ Boom Only)” onpage 32.• Outer sensor installation information in “Mount the Boom Sensors” on page 25.• Inner sensor installation information in “Mount the Boom Sensors” on page 25.• Center sensor installation instructions in “Mount the Boom Sensors” on page 25.• Proximity sensor installation instructions in “Proximity Sensor” on page 33.1. Radar Sensors2. ABM Node3. REM Node4. Hydraulic Valve5. Tilt Sensor6. Rotary Sensor7. Variable Damper8. Proximity Sensor1 123, 46 75588 |
Related manuals for Raven AutoBoom XRT
manualsdatabase
Your AI-powered manual search engine