Raymarine E SERIES Installation Instructions Manual

Also see for A series: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation instructions

Contents

Raymarine E SERIES Installation Instructions Manual Manual pdf 60 page image

5.1 Mounting - a SeriesMountingthe display can be surface mounted.Before mounting the unit, ensure that you have:• Selected a suitable location.• Identified the cable connections and route that thecables will take.• Detached the front bezel.D12585-21. Check the selected location for the unit. A clear,flat area with suitable clearance behind the panelis required.2. Drill or knock out the 4 mounting holes on the unitD12588-13. Fix the appropriate cutting template suppliedwith the product, to the selected location, usingmasking or self-adhesive tape.4. Using a suitable hole saw (the size is indicatedon the template), make a hole in each corner ofthe cut-out area.5. Using a suitable saw, cut along the inside edgeof the cut-out line.6. Ensure that the unit fits into the removed areaand then file around the rough edge until smooth.7. Drill 4 holes as indicated on the template toaccept the securing screws.8. Place the gasket onto the display unit and pressfirmly onto the flange.9. Connect the power, data and other cables to theunit.10.Slide the unit into place and secure using theprovided fixings.Note: The supplied gasket provides a sealbetween the unit and a suitably flat and stiffmounting surface or binnacle. The gasket shouldbe used in all installations. It may also benecessary to use a marine-grade sealant if themounting surface or binnacle is not entirely flat andstiff or has a rough surface finish.Bracket (trunnion) mountingThe display can be mounted on a trunnion bracket.Before mounting the unit ensure that you have:• Selected a suitable location.• Identified the cable connections and route that thecables will take.• Attached the front bezel.D12578-21. Mark the location of the mounting bracket screwholes on the chosen mounting surface.2. Drill holes for the screws using a suitable drill,ensuring there is nothing behind the surface thatmay be damaged.3. Use the fixings supplied with the mountingbracket to attach securely.4. Attach the display to the mounting bracket.Attaching the front bezelThe following procedure assumes that the unit hasalready been mounted in position.1. Carefully lift one edge of the screen protectionfilm, so that it is accessible for removing whenunit installation is complete.60 a Series / c Series / e Series installation instructions