Chapter 2: Basic Operation 13ContrastTo set the display contrast:1. With the autopilot in Standby mode, hold down the disp key for1 second to show the illumination adjust display.2. Hold down the disp key for 1 second again, to display theCONTRAST adjust page.3. Use the up and down arrow keys to set the required contrast level(from 1 to 15).The display times out to normal operation after 10 seconds of keypadinactivity.2.7 Data PagesThe disp key is used to cycle through Data Pages of SeaTalk orNMEA data. Once a Data Page is selected, this page becomes theprincipal autopilot display. The autopilot mode displays (Standby,Auto, Track Wind and Manual) then become “pop-ups”, and aredisplayed whenever the autopilot mode is changed or a course changeis made. The duration of pop-up pages is user-adjustable, from 1 to 10seconds. You can use Data Pages as follows:• Press disp to display each Data Page in turn.• When the last Data Page is cycled, the display returns to the currentautopilot mode display (for example, Standby).• To return to a previous Data Page, press disp for 1 second within 2seconds of displaying a page. You can continue to move backwardsthrough the Data Page sequence in this way.Up to 15 Data Pages are available using the disp key. The number ofpages, and the information displayed on each page, depends on theselections made in User Setup (see Section 4.1).The following diagram shows the default Data Page settings.
