Water ingressWater ingress disclaimerAlthough the waterproof rating capacity of this product meetsthe IPX6 standard, water intrusion and subsequent equipmentfailure may occur if the product is subjected to commercialhigh-pressure washing. Raymarine will not warrant productssubjected to high-pressure washing.DisclaimersThis product (including the electronic charts) is intended to beused only as an aid to navigation. It is designed to facilitate useof official government charts, not replace them. Only officialgovernment charts and notices to mariners contain all thecurrent information needed for safe navigation, and the captainis responsible for their prudent use. It is the user’s responsibilityto use official government charts, notices to mariners, cautionand proper navigational skill when operating this or any otherRaymarine product. This product supports electronic chartsprovided by third party data suppliers which may be embeddedor stored on memory card. Use of such charts is subject tothe supplier’s End-User Licence Agreement included in thedocumentation for this product or supplied with the memory card(as applicable).Raymarine does not warrant that this product is error-free or thatit is compatible with products manufactured by any person orentity other than Raymarine.This product uses digital chart data, and electronic informationfrom the Global Positioning System (GPS) which may containerrors. Raymarine does not warrant the accuracy of suchinformation and you are advised that errors in such informationmay cause the product to malfunction. Raymarine is notresponsible for damages or injuries caused by your use orinability to use the product, by the interaction of the product withproducts manufactured by others, or by errors in chart data orinformation utilized by the product and supplied by third parties.Chart cards and memory cardsMemory cards are used for archiving data and chart cardsprovide additional or upgraded charts.Compatible cardsThe following types of memory or chart card are compatible withyour Raymarine product:• micro Secure Digital Standard-Capacity (microSDSC)• micro Secure Digital High-Capacity (microSDHC)Note: The maximum card capacity supported is 32 GB.Chart cardsYour product is pre-loaded with electronic charts (worldwidebase map). If you wish to use different chart data, you can insertcompatible chart cards into the unit's card slot.Use branded chart cards and memory cardsWhen archiving data, Raymarine recommends the use of qualitybranded memory cards. Some brands of memory card may notwork in your unit. Please contact customer support for a listof recommended cards.EMC installation guidelinesRaymarine equipment and accessories conform to theappropriate Electromagnetic Compatibility (EMC) regulations,to minimize electromagnetic interference between equipmentand minimize the effect such interference could have on theperformance of your systemCorrect installation is required to ensure that EMC performanceis not compromised.For optimum EMC performance we recommend that whereverpossible:• Raymarine equipment and cables connected to it are:– At least 1 m (3 ft) from any equipment transmitting orcables carrying radio signals e.g. VHF radios, cables andantennas. In the case of SSB radios, the distance shouldbe increased to 7 ft (2 m).– More than 2 m (7 ft) from the path of a radar beam. Aradar beam can normally be assumed to spread 20 degreesabove and below the radiating element.• The product is supplied from a separate battery from that usedfor engine start. This is important to prevent erratic behaviorand data loss which can occur if the engine start does nothave a separate battery.• Raymarine specified cables are used.• Cables are not cut or extended, unless doing so is detailed inthe installation manual.Note: Where constraints on the installation preventany of the above recommendations, always ensure themaximum possible separation between different items ofelectrical equipment, to provide the best conditions for EMCperformance throughout the installationRF exposureThis transmitter with its antenna is designed to comply with FCC/ IC RF exposure limits for general population / uncontrolledexposure. The WiFi / Bluetooth antenna is mounted behind thefront facia on the left hand side of the screen. It is recommendedto maintain a safe distance of at least 1 cm from the left handside of the screen.FCCCompliance Statement (Part 15.19)This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions:1. This device may not cause harmful interference.2. This device must accept any interference received, includinginterference that may cause undesired operation.FCC Interference Statement (Part15.105 (b))This equipment has been tested and found to comply with thelimits for a Class B digital device, pursuant to Part 15 of the FCCRules.These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance withthe instructions, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interferenceby one of the following measures:1. Reorient or relocate the receiving antenna.2. Increase the separation between the equipment andreceiver.3. Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.4. Consult the dealer or an experienced radio / TV technicianfor help.10 New a Series / New c Series / New e Series