19.8 Pan and tilt camera — old camera interfaceThe thermal camera application menu options for a pan and tilt thermal camera with the old camera interface are shown below.Activate Camera Brings the thermal camera out of standby mode. (only available when camera is in standby.)Pause Image • On• Off (default)Camera Home Select to return the camera to its home position.Image Options Select to display the Image Options sub-menu.• Color– Red– Greyscale– Glowbow– Rainbow– Fusion• Scene– Night Running– Night Docking– Day Running– Man Overboard• Thermal / Visible• Reverse video• Rear View• SurveillanceAdjust Contrast Select to display the Adjust Contrast sub-menu.• Contrast• Brightness• ColorStandby Select to place the camera in to standby mode. (only available when camera is activated.)Camera Set-up Select to display the Camera Set-up menu.• Set Home Position• Camera menu — (Onscreen display (OSD) menu)• Align CameraCamera Set-up menuSet Home Position Sets the camera’s current position as the Camera Home position.Camera menu Provides access to the camera’s onscreen display (OSD) menu options.Align Camera Enables changes to camera’s horizontal alignment.Note: The thermal camera menu options available are dependant on the software version of your multifunction display andthermal camera. If options are different than listed above please refer to the manual that accompanied your thermal camera and /or the installation and operations handbook which accompanied your multifunction display.Note: It may be possible to update your camera to the new camera interface. Please contact your Raymarine dealer for details.OSD menu optionsSetup menusThe setup menus provide a range of tools and settings toconfigure the thermal camera.The menus can be accessed from any controller on the system.The menus are overlaid onto the video image.Note: The on-screen menus only appear on the thermalcamera image. They are not available when viewing thevisible light image (on dual payload models).Menus availableEnable Point Mode/ Disable PointModeSelecting Enable Point mode will turn point modeon, selecting disable point mode will turn pointmode off. Only applies to models with mechanicalstabilization.Video Setup This menu is used to set the video configurationoptions.Set Symbology Settings associated with the status icons.UserProgrammableButtonConfigure the USER button on the JCU.242 New a Series / New c Series / New e Series
