7.10 Using the log, trip andtemperature pagesTo cycle through the available log, trip and watertemperature pages follow the steps below.10152025303540455055 60 53D12534-2TripTripTripTripRe s e t12341. Current Speed page2. Log page3. Trip page4. Water temperature pageDuring normal operation:1. Use the Trip button to cycle through the availablepages.2. From the Trip page, press and hold the Resetbutton for approximately 3 seconds to reset thereading.7.11 Using the timersTo cycle through and use the Race Timer pages andStop Watch page follow the steps below.D12535-2Time r Time rTime rDuring normal operation:1. Press the Timer button to cycle through theavailable timers.2. Press the Reset button to start the timer.3. With the timer running, press the Reset buttonto pause the timer.4. With the timer running, press and hold the Resetbutton for 1 second to reset the timer.Note: After the race timers have counted downto zero they will then start to count upwards fromzero.Setting the race start timerThe race start timers can be set from 1 to 15 minutes.+-D12536-2++1 2Time rTime rRe s e tRe s e tTime r Re s e tWith a race timer displayed1. Press the Timer and Reset buttons at the sametime to adjust the race timer.The set time will flash.2. To change the race timer:i. Use the Reset button to increase the racetimer start value, orii. Use the Timer button to decrease the racetimer start value.iii. Press the Timer and Reset buttons at thesame time to confirm the new value.Timer buzzerThe Timer buzzer is enabled or disabled duringcalibration see the User calibration section.When using a race timer with the timer buzzerenabled, the buzzer will:• Short double beep every minute.• 3 Long beeps at the start of the last 30 seconds.• Short beep once for each of the last 10 seconds.• Long beep at zero.i50 Speed 53