Raymarine i60 Installation And Operation Instructions Manual

Contents

Raymarine i60 Installation And Operation Instructions Manual Manual pdf 32 page image

6.5 CalibrationBefore first use calibration procedures must be carried out toensure optimum performance of the instrument with the vessel.The calibration procedures are:• User calibration• Intermediate calibration• Group setup• Dealer calibrationNote: Group setup is for group illumination and is not part ofthe calibration process.User calibrationThe i60 Close hauled wind is a repeat display and as such doesnot require calibration, the steps below apply to the calibration ofthe i60 Wind instrument only.User calibration options include:• Wind angle offset• Wind speed unitsLinearizing and aligning the wind transducerYou can linearize and align the wind transducer by followingthe steps below.You will need to be underway, with sufficient space to turn in alarge circle unhindered.1. Slowly turn the vessel through 2 complete circles.x 2D12415-1This procedure automatically linearizes the wind vane. Asuccessful linearization is indicated by the digital displayflashing and a buzzer sounding three beeps.2. Press and hold the Power and True / App buttonsimultaneously for approximately 2 seconds to enter the usercalibration menu.TrueApp+ D12488-110152025303540455055 60 523. Press the Power button to display the wind angle offset page.D12489-14. Sail your vessel directly into the wind and adjust the analogpointer to 0, using the VMG and Tack buttons.D12490-1Ta ckVMGThe VMG button will decrease the current value and theTack button will increase the current value. As you do this,the wind angle offset shows the amount of correction youhave applied.5. To exit the user calibration pages at any time press andhold the Power and True / App buttons simultaneously forapproximately 2 seconds.Selecting wind speed unitsWind speed units can be displayed in either knots or meters persecond. To change the wind speed units follow the steps below.From the user calibration pages:1. Press the Power button to display the wind speed unitspage, orD12491-12. Use the VMG and Tack buttons to select the required windunits.3. To exit the user calibration pages at any time press andhold the Power and True / App buttons simultaneously forapproximately 2 seconds.Intermediate calibrationIntermediate calibration allows you to:i60 Wind i60 Close hauled windCheck instrument software version. Check instrument software version.Check the instrument status (eithermaster or repeater).10152025303540455055 60 54+D12492-1CALTrueAppChecking the software versionYou can check the software version of the unit by following thesteps below.During normal operation:1. Press and hold the Power and True / App buttonssimultaneously for approximately 4 seconds.The current software version is displayed. The softwareversion page will time-out automatically after 8 seconds ofinactivity.2. Press the Power button to display the instrument status.Checking the instrument statusYou can check the instrument display's status by following thesteps below.From the software version page:1. Press the Power button.The instrument status is displayed (r0 = master and r1= repeater). The instrument status page will time-outautomatically after 8 seconds of inactivity.Dealer calibrationThe dealer calibration procedures include:• Setting User calibration options on or off.• Setting required wind angle and speed response.• Setting the velocity made good (VMG) response.• Setting boat show mode on or off.• Restore factory defaultSetting dealer calibration optionsTo set the dealer calibration options follow the steps below:During normal operation:1. Press and hold the Power and True / App buttons forapproximately 14 seconds to display the dealer cal entrypage.10152025303540455055 60 514+ D12493-1TrueAppCAL2. Press the VMG and Tack buttons simultaneously to displaythe user calibration access page.+ D12494-1Ta ckVMGCALCAL32 i60