Raymarine i60 Installation And Operation Instructions Manual

Contents

Raymarine i60 Installation And Operation Instructions Manual Manual pdf 36 page image

7.1 PagesThe pages available depend on the display variant and areshown in the table below:i60 Wind i60 Close hauled windWind speed Wind speed*Beaufort wind speed *Maximum wind speed*Maximum wind speed VMG*Maximum true wind speed alarm Tack*Low true wind speed alarm*High apparent wind angle alarm*Low apparent wind angle alarmVMGTackNote: *These pages are temporary pages and will time-out tothe previous permanent page after 8 seconds of inactivity.Changing pagesDuring normal operation:1. Press either the Power button to cycle through the pages.2. Press the VMG button to display VMG information.3. Press the Tack button to display tack information.7.2 i60 Wind operationWhen connected to a relevant rotavecta or wind vane transducerthe i60 provides:• True and apparent wind direction and speed. Wind speed isdisplayed either in knots, meters per second or as Beaufortscale values.• Velocity made good (VMG) information, when vessel speedinformation is available on the network.• Tack angle, when heading information is available on thenetwork.• Maximum wind speed.• High and low true wind speed alarms.• High and low apparent wind angle alarms.Note: Alarms are only available on the i60 Wind instrument,when set as a master unit. No alarms are available on the i60Close hauled wind instrument.i60 display informationThe i60 instrument's display consists of an analogue pointerand digital display.Analogue displayThe analogue display pointer shows either true or apparent winddirection (Depending on setting).Digital displayThe digital display LCD shows the following wind information.• Beaufort wind speed• True / apparent wind speed• Velocity made good (VMG)• Tack heading• Maximum wind speed• Wind alarm dataUsing the display (Power) buttonHILOdispKTSKTSKTSLO KTSKTSDisplayDisplayDisplayDisplayDisplayDisplayDisplayTack10152025303540455055 60 53D12552-1During normal operation:1. Use the Display button to cycle through the available pages.2. Press and hold the Tack buttons for 3 seconds to reset themaximum wind speed to the current wind speed.Note: All pages except for the Current wind speed page aretemporary and will time-out after 8 seconds.36 i60