Raypak 302-902 Installation And Operating Instructions Manual

Raypak 302-902 Installation And Operating Instructions Manual Manual pdf 61 page image

SECTION Q: MAINTENANCESUGGESTED MINIMUM MAINTENANCE SCHEDULE:Regular service by a qualified service agency and maintenance must be performed to assure maximum boiler operatingefficiency.Maintenance as outlined below may be performed by the owner.Yearly (Beginning of each heating season):1. Annual service call by qualified service agency.2. Visually check top of vent for soot. Call service person to clean. Some sediment at bottom of vent is normal.3. Visually inspect venting system for proper function, deterioration or leakage.4. Check that boiler area is free from combustible materials, gasoline, and other flammable vapors and liquids.5. Check for and remove any obstruction to the flow of combustion or ventilation air to boiler.6. Follow pre-start-up check in Section N.7. Visually inspect burner flame. Should see light blue flame. Visually inspect hot surface ignitor for damage, crackingor debris build-up.8. Check operation of safety devices. Refer to manufacturerís instructions.9. Follow oil-lubricating instructions on circulator. Over-oiling will damage circulator. Water-lubricatedcirculators do not need oiling.10. To avoid potential of severe burn, DO NOT REST HANDS ON OR GRASP PIPES. Use a light touch - returnpiping will heat up quickly.11. Check blower and blower motor. Clean and oil as necessary.12. Check for piping leaks around circulators, relief valves and other fittings. Repair, if found. DO NOT use petroleumbased stop leak.Daily:1. Check that boiler area is free from combustible materials, gasoline, and other flammable vapors and liquids.2. Check for and remove any obstruction to the flow of combustion or ventilation air to boiler.Monthly:1. Check for piping leaks around circulators, mixing valves, relief valves, and other fittings.If found, repair at once. DO NOT use petroleum-based stop leak compounds.2. Visually inspect burner flame.3. Visually inspect venting system for proper function, deterioration or leakage.4. Check air vents for leakage.Periodically:1. Check relief valve. Refer to manufacturerís instructions on valve.2. Test low water cutoff, if used. Refer to manufacturerís instructions.3. Clean screen and air filter in intake.61