Red Epic 4K Broadcast Module Operation Manual
                            | |
Contents
| 
R E D 4 K B R O A D C A S T M O D U L E O P E R AT I O N G U I D ECOPYRIGHT © 2015 RED.COM, INC 955-0072, REV-E | 3DISCLAIMERRED has made every effort to provide clear and accurate informa-tion in this document, which is provided solely for the user’s infor-mation. While thought to be accurate, the information in this docu-ment is provided strictly “as is” and RED will not be held responsiblefor issues arising from typographical errors or user’s interpretationof the language used herein that is different from that intended byRED. All safety and general information is subject to change as aresult of changes in local, federal or other applicable laws.RED reserves the right to revise this document and make changesfrom time to time in the content hereof without obligation to notifyany person of such revisions or changes. In no event shall RED, itsemployees or authorized agents be liable to you for any damagesor losses, direct or indirect, arising from the use of any technical oroperational information contained in this document.For comments or questions about content in this Operation Guide,please send a detailed email to OpsGuides@red.com.COPYRIGHT NOTICECOPYRIGHT© 2015 RED.COM, INC.All trademarks, trade names, logos, icons, images, written material,code, and product names used in association with the accompa-nying product are the copyrights, trademarks or other intellectualproperty owned and controlled exclusively by RED.COM, INC.TRADEMARK DISCLAIMERAll other company, brand and product names are trademarks or reg-istered trademarks of their respective holders. RED has no affiliationto, is not associated or sponsored with, and has no express rightsin third-party trademarks. Torx is a registered trademark of AcumentIntellectual Properties, LLC in the United States or other countries.COMPLIANCE STATEMENTSINDUSTRIAL CANADA EMISSION COMPLIANCE STATE-MENTSThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la normeNMB-003 du Canada.FEDERAL COMMUNICATIONS COMMISSION (FCC) STATE-MENTSThis equipment has been tested and found tocomply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules.These limits are designed to provide reason-able protection against harmful interferencein a residential installation. This equipmentgenerates, uses and can radiate radio fre-quency energy and, if not installed and usedin accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that inter-ference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or moreof the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected. Consult the dealer or an experienced radio/TV technician forhelp.In order to maintain compliance with FCC regulations, shieldedcables must be used with this equipment. Operation with non-ap-proved equipment or unshielded cables is likely to result in interfer-ence to radio and TV reception. The user is cautioned that changesand modifications made to the equipment without the approval ofmanufacturer could void the users authority to operate this equip-ment.NOTE: This device complies with Part 15 of the FCC Rules.Operations subjected to the following two conditions (1) this devicemay not cause harmful interference, and (2) this device must acceptany interference received, including that may cause undesirable in-terference.CAUTION: Regulations of the FCC and FAAprohibit airborne operation of radio-frequencywireless devices because there signals couldinterfere with critical aircraft instruments.CAUTION: If the device is changed or modifiedwithout permission from RED, the user mayvoid his or her authority to operate the equip-ment.AUSTRALIA AND NEW ZEALAND STATEMENTSRED declares that the radio equipment described in this documentcomply with the following international standards. IEC 60065 – Product SafetyRED declares digital devices described in this document complywith the following Australian and New Zealand standards. AS/NZS CISPR 22 – Electromagnetic Interference AS/NZS 61000.3.2 – Power Line Harmonics AS/NZS 61000.3.3 – Power Line FlickerJAPAN STATEMENTSThis is a Class B product based on thestandard of the Voluntary Control Councilfor Interference (VCCI) for information tech-nology equipment. If this equipment is usednear a radio or television receiver in a do-mestic environment, it may cause radio in-terference. Install and use the equipmentaccording to the instruction manual. |
Related manuals for Red Epic 4K Broadcast Module
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine